Page 1
Revised 7/01
Los Angeles Ca. 90058
www.americandj.com
4295 Charter Street
American DJ
User Instructions
attempt any repairs yourself, doing so will void your manufactures war-
ranty. In the unlikely event your unit may require service please contact
different type fuse from that which is recommended may cause fire or
electric shock and will void the manufactures warranty.
©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 2
of 2 amps is reached. If the fuse needs replacement, always replace
the fuse with same exact type that was remove, unless otherwise
instructed by an authorized American DJ
® service technician. Use of a
your nearest American DJ® dealer.
Safety Issues: This unit may blow a fuse if the maximum allotted load
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
Warning! To prevent or reduce the risk of electrical shock or fi re, do
Voice: (800) 322-6337
Fax: (323) 582-2610
5:00 p.m. Pacifi c Standard Time.
demands of theatrical groups and those that desire an incredible effect
without strong fl ashing lights or fog.
Customer Support: American DJ® provides a toll free customer sup-
port line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 9:00 a.m. to
Introduction: The American DJ® Refl ections II
ulates rippling water and when used with a yellow or red gel this unit
can also simulate fi re. The Refl ections II™ was created to meet the
™
is an effect that sim-
can DJ
®. Every Refl ections II™ has been thoroughly tested and has
Reflections II™ Introduction
Unpacking: Thank you for purchasing the Refl ections II™ by Ameri-
been shipped in perfect operating condition. Carefully check the ship-
ping carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fi xture for any
damage and be sure all equipment necessary to operate the system
has arrived intact. In the event damage has been found or parts are
missing, please contact our toll free customer support number for fur-
ther instructions.
Page 2
serviceable parts inside
• Never operate this unit when it’s cover is removed
• Never plug this unit in to a dimmer pack
• Do not attempt to operate this unit, if it becomes damaged
• This unit is intended for indoor use only, use of this product outdoors
voids all warranties
• During long periods of non-use, disconnect the unit’s main power
• Always mount this unit in safe and stable matter
• Power cords should be routed so they are not likely to be walked on,
pinched by items placed upon or against them.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 5 for cleaning details.
• This unit should be situated away from heat sources such as radia-
tors, heat registers, stoves, or other appliances (including amplifiers)
that produce heat. Always be sure to mount this unit in an area
that will allow proper ventilation. Allow about 6” (15 cm) between this
device and a wall.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits a
marked change in performance.
• Do not remove the cover under any conditions. There are no user
Reflections II™ Safety Precautions
• To reduce the risk of electrical shock or fi re, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit
• Be sure that the local power outlet match that of the required voltage
for your unit
• Do not attempt to operate this unit if the power cord has been frayed
or broken
• Do not attempt to remove or break off the ground prong from
the electrical cord. This prong is used to reduce the risk of electrical
shock and fi re in case of an internal short
• Disconnect from main power before making any type of connection
electrical outlet. After plugging this fixture in, the units “Reflections II™
shaped lenses will spin back and forth to an audio source. The unit
will react to the low frequencies of music via its internal microphone.
The audio sensitivity is preset there no need for any adjustments. If
after plugging the unit in there is no lamp output check the fuse and
lamp. If the fuse and lamp are good, please contact customer support
for further instructions. For best results, we suggest using with fog or
special effects smoke. This will enhance the effects by allowing you
to see the beams of light.
©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 4©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 3
General Operation:
This fixture is designed to operate as a stand alone unit, it will react
to low frequencies of an audio source. The unit has been equipped
with a lamp and is ready to be hung or set on a flat surface, there is
no assembly necessary and no need of a controller of any type. The
unit is ready to be plugged in out of the box. Plug the unit’s power cord
in to a standard 110v~120v electrical outlet. There is no power switch,
the unit should automatically turn on after plugging the unit in to an
Power Supply: Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ® Refl ections II™ before attempting operation.
• Low Power Consumption
Reflections II™ Set-Up/Operation
Reflections II™ Features
regarding the use and maintenance of this unit. Please keep this
manual with the unit, for future reference.
• Micro-Stepping Motors for Smooth Movement
• Full Focusing
• Fan Cooled
• Easy Lamp Replacement
• Long Life ZB-JCR H5 (15v/150w) Lamp - 500 Hours
• Light Weight Compact Design
To optimize the performance of this product, please read these operat-
ing instructions carefully to familiarize yourself with the basic operations
of this unit. These instructions contain important safety information
Reflections II™ General Instructions
Page 3
©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 5
number.
® customer support for a R.A.
The Reflections II™ carries a 90 day limited warranty. Please fill out
the enclosed warranty card to validate your purchase. All returned
service items whether under warranty or not, must be freight pre-paid
and accompany a return authorization (R.A.) number. If the unit is
under warranty you must provide a copy of your proof of purchase
invoice. Please contact American DJ
Reflections II™ Warranty Registration
back in.
2. Use a brush to wipe down the cooling vents and fan grill.
3. Clean the external lens with glass cleaner and a soft cloth every
20 days.
4. Clean the internal lens with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
dust, dew). In heavy club use we recommend cleaning on a monthly
basis. Periodic cleaning will ensure longevity, and crisp output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside
casing.
the environment in which the fixture operates (I.e. smoke, fog residue,
internal and external optical lenses and mirror should be carried out
periodically to optimize light output. Cleaning frequency depends on
Fixture Cleaning: Due to fog residue, smoke, and dust cleaning the
prolong the lamp life and ensure fixture longevity.
Reflections II™ Cleaning
for 10 consecutive minutes. Following the prescribed duty cycle will
Reflections II™ Duty Cycle
Duty Cycle: Because of the high temperature that may build up
in the unit during normal operation, it is necessary to assign a duty
cycle to this unit. A duty cycle is a recommended operating cycle
associated with a fixture. The duty cycle assigned to this unit is 10
minutes off for every 20 minutes of activity. This means for every 20
consecutive minutes the unit operates the unit should be shut down
©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 6
Also, never move the fixture until the lamp has
had ample time to cool. Remember, lamps are not
covered under warranty conditions.
as the oil from your hands will shorten lamp life.
This fixture is fitted with a halogen lamp which
is highly susceptible to damage if improperly han-
dled. Never touch the lamp with your bare fingers
5. Replace the lamp with an exact match and reassemble.
Halogen Lamp Warning:
Lamp Replacement: Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power and
allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a removable lamp cover retained by a two thumb screws.
1. Be sure to follow the proper handling procedures that deal
with halogen lamps.
2. Remove the two thumb screws located on top of the unit. These
screw hold the lamp socket cover in place.
3. Remove the lamp cover and put aside.
4. Carefully remove the old lamp and discard it in the trash.
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Fuse Replacement: Disconnect the unit’s main power supply. Insert
a standard flat head screw driver in to the fuse holder housing. Turn
the screwdriver in counter-clockwise direction to remove the fuse
holder. Remove the fuse holder to expose the fuse. Remove the old
fuse and discard it. Replace the fuse with the same type. Insert the
fuse holder back into it’s housing and turn it in clockwise direction to
lock the holder in place.
to blow, STOP using the unit. Contact customer support for further
Warning: If, after replacing the lamp or fuse either one continues
unit and will void the manufactures warranty.
Replacing with anything other than the specified part can damage the
unless otherwise specified by an authorized American DJ® technician.
Caution: Always replace with the exact same type lamp and fuse,
Reflections II™ Lamp & Fuse Replacement
Page 4
H. Lamps are not covered under this or any other warranty either written or implied.
©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 7
sumer’s and or Dealer’s sole remedy shall be such repair or replacement as is expressly
provided above; and under no circumstances shall American DJ® be liable for any loss or
warranties of merchantability or fi tness, are limited in duration to the warranty period set
forth above. And no warranties, whether expressed or implied, including warranties of mer-
chantability or fi tness, shall apply to this product after said period has expired. The con-
sory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ
its products without any obligation to include these changes in any products theretofore
manufactured.
F. No warranty, whether expressed or implied, is given or made with respect to any acces-
damage, direct or consequential, arising out of the use of, or inability to use, this product.
G. This warranty is the only written warranty applicable to American DJ
supersedes all prior warranties and written descriptions of warranty terms and conditions
heretofore published.
parts, at the sole discretion of American DJ®. All products covered by this warranty were
manufactured after January 1, 1990, and bear identifying marks to that effect.
E. American DJ® reserves the right to make changes in design and/or improvements upon
D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period specifi ed above, American DJ
parts at its expense, and will absorb all expenses for warranty service and repair labor by
reason of defects in material or workmanship. The sole responsibility of American DJ® under
this warranty shall be limited to the repair of the product, or replacement thereof, including
charges must be pre-paid. If the requested repairs or service (including parts replacement)
American DJ® factory unless prior written authorization was issued to purchaser by Ameri-
can DJ®; if the product is damaged because not properly maintained as set forth in the
instruction manual.
accessories are shipped with the product, American DJ® shall have no liability whatsoever
for loss of or damage to any such accessories, nor for the safe return thereof.
C. This warranty is void if the serial number has been altered or removed; if the product
is modifi ed in any manner which American DJ
ability of the product; if the product has been repaired or serviced by anyone other than the
are within the terms of this warranty, American DJ® will pay return shipping charges only
to a designated point within the United States. If the entire instrument is sent, it must be
shipped in its original package. No accessories should be shipped with the product. If any
is sought.
B. For warranty service, send the product only to the American DJ
date of purchase. This warranty shall be valid only if the product is purchased within the
United States of America, including possessions and territories. It is the owner’s responsibil-
ity to establish the date and place of purchase by acceptable evidence, at the time service
90 DAY LIMITED WARRANTY
A. American DJ® hereby warrants, to the original purchaser, American DJ® products to be
free of manufacturing defects in material and workmanship for a period of 90 days from the
Reflections II™ Warranty
® in connection with this product, including
® Products and
American DJ Supply Group of Companies World Headquarters:
Web: www.americandj.com E-mail: [email protected]
4295 Charter Street Los Angeles, CA 90058 USA
® concludes, after inspection, affects the reli-
® will replace defective
Please Note: Specifi cations and improvements in the design
of this unit and this manual are subject to change without any
prior written notice.
® factory. All shipping
Lamps: ZB-JCR/H5 15V/150W
Voltage: 120v/60Hz
Dimensions: 4H x 7 3/4W x 6 1/4L
Colors White
Weight: 5 Lbs.
Fuse: 2 Amp GMA
Duty Cycle: 20 min. on/10 min. off
Working Position: Any Safe, Secure Position
Warranty: 90 Days
Technical Specifications:
Model: Reflections II™
Tel: 323-582-2650 Fax: 323-582-2610
©American DJ Supply
Loading...