Ademco 8DLWIFI Users Manual

800-10225 Rev. A 10/11

L5000-Wi-Fi

Communications Module

INSTALLATION GUIDE

About the Communications Module

The L5000-W-Fi communications module is intended to provide compatible Honeywell LYNX Touch control panels with a Wi-Fi connection.

Compatible Controls

Control Firmware Level Field Update Rev Installation Guide

LYNX Touch TBD 800-10614 QuickConnect Touch TBD

The module connects directly to the control panel and is powered via the control panel’s connection.

Mounting the Module

Mount the module component side up in the control panel as shown in Figure 1. Ensure that module’s receptacle is securely seated on the control’s edge connector.

TBD

RECEPTACLE

L5000-WiFi

LYNX TOUCH

EDGE CONNECTOR

5000-100-205-V0

Figure 1. Installing the L5000-Wi-Fi Communications Module

Programming Notes

Programming associated with the L5000-Wi-Fi module is accomplished as part of the Control Panel Programming. Refer to the Control Panel Installation and Setup Guide for additional information.

1. The Remote Access Serial option must be set to “Enabled”.

2. The Multi Mode Serial option must be set to “Enhanced Reports”.

Specifications

Board Dimensions: 1.25” W x 2.875” L x 0.3125” D Current Drain: TBDmA nominal; TBDmA max Input Voltage: TBDVDC Wire Run Length: Temperature: 32°F (0°C) to 140°F (60°C)

TBD ft max with TBD AWG unshielded wire

REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE CONTROL WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND LIMITATIONS OF THE ENTIRE SYSTEM.

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENTS

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.

FCC CLASS B STATEMENT

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information: This equipment generates and uses radio frequency energy and if not inst alled and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to ra dio or television reception, which can be determined by turning the equipment off and on, the u ser is encouraged to try to correct the interference by one or more of the following measures:

• If using an indoor antenna, have a quality outdoor antenna installed.

• Reorient the receiving antenna until interference is reduced or eliminated.

• Move the radio or television receiver away from the receiver/control.

• Move the antenna leads away from any wire runs to the receiver/control.

• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

• Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA CLASS B STATEMENT

ICES-003 Class B Notice - Avis NMB-003, Classe B This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

FCC / IC STATEMENT

This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y compris les interferences causant une reception indésirable.



WARNING: The L5000-Wi-Fi must be installed to provide a separation distance of at least 20 cm from all persons.

RF Exposure

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

www.honeywell.com/security

Ê800-10225lŠ

800-10225 10/11 Rev. A