Ademco 8DLLRS500 Installation guide

This wireless siren/strobe is

SIREN

OPEN /

OPEN / OPEN

NOTE

FC: NOTE

SP: NOTE

PA: NOTE

Enroll / Enroll / Enroll / Enroll

LEDS and SOUNDERS / LEDS and SOUNDERS / LEDS and SOUNDERS / LEDS

and SOUNDERS

R / W

G / W

Sounder

Status

Power Up – Device enrolled /

Tamper Activated /

PLEASE GO TO THE LAST PAGE FOR FCC/IC AGENCY STATEMENTS

intended for use with Honeywell controls that support SiX™ series devices.

FC: This wireless siren/strobe is intended for use with Honeywell controls that support SiX™ series devices.

SP This wireless siren/strobe is intended for use with Honeywell controls that support SiX™ series devices.

PA: This wireless siren/strobe is intended for use with Honeywell controls that support SiX™ series devices.

: Once enrolled, the device cannot be used with another system until it is removed from the current controller. See the controller’s instructions,

device cannot be used with another system until it is removed from the current controller. See the controller’s instructions,

device cannot be used with another system until it is removed from the current controller. See the controller’s instructions.

: Once enrolled, the

3 sec

Starts chirping after 7 days, continues until the batteries are replaced or die. / Starts chirping after 7 days, continues

until the batteries are replaced or die / Starts chirping after 7 days, continues until the batteries are replaced or die / Starts chirping after 7 days, continues until the batteries are replaced or die

Power Up – Enrollment /

Power Up – Enrollment / Power Up – Enrollment / Power Up – Enrollment

Power Up – Device enrolled / Power Up – Device enrolled/ Power Up – Device enrolled

System is Disarmed /

System is Disarmed / System is Disarmed / System is Disarmed

System is Armed /

System is Armed / System is Armed / System is Armed

Smoke or CO Alarm /

Smoke or CO Alarm / Smoke or CO Alarm / Smoke or CO Alarm

Burglary Alarm /

Burglary Alarm / Burglary Alarm / Burglary Alarm

Low Battery / Low Battery /

Low Battery / Low Battery

Tamper Activated / Tamper Activated / Tamper Activated

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

Ê800-15964kŠ

NOTE: After enrolling and before mounting

FC: NOTE

SP: NOTE

PA: NOTE

Mount / Mount /

Mount / Mount

Program /

Program / Program

Approval Listings:

Specifications:

Range: RF Frequency Batteries Tamper Operating Temperature

Relative Humidity

Dimensions

Product must be tested at least once each year / Le fonctionnement du produit doit être vérifié au moins une fois par année / El producto debe ser probado al menos una vez al año / O produto deve ser testado pelo menos uma vez por ano

BATTERY CAUTION: Risk of fire,

Replace Battery /

Replace Battery / Replace Battery

Support / Support / Support / Support

U.S. warranty / U.S. warranty / U.S. garantie / U.S. garantia

FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA STATEMENTS

FCC / IC STATEMENT

RF Exposure Warning

Mise en Garde Exposition aux Frequences Radio:

permanently, conduct Go/No Go tests (see controller’s instructions) to verify adequate signal strength. Adjust the device location and orientation as necessary.

: After enrolling and before mounting permanently, conduct Go/No Go tests (see controller’s instructions) to verify adequate signal strength. Adjust the device location and orientation as necessary.

Consult the Controller’s instructions to program the Siren Services: Siren Chime mode sound level; Tamper, and Temperature Sensing.

FC: Consult the Controller’s instructions to

35dB 1

program the Siren Services: Siren Chime mode sound level; Tamper, and Temperature Sensing.

SP: Consult the Controller’s instructions to program the Siren Services: Siren Chime mode sound level; Tamper, and Temperature Sensing.

PA: Consult the Controller’s instructions to program the Siren Services: Siren Chime mode sound level; Tamper, and Temperature Sensing.

55dB

85dB 2

Factory default / Valeurs par défaut du fabricant / Defecto de fábrica / Padrão de fábrica

Life Safety / Life Safety / Life Safety /

Life Safety

FCC / IC ETL Listed to UL985 / UL1023 cETL Listed to ULC-S545 &

ULC/ORD-C1023 RoHS

www.honeywell.com/security

0’- 25’/ 0 – 7.6m; Selectable

: 2.4GHz

: 4 x 1.5V, AA Lithium; Honeywell 462

: Cover and Wall

Compliance 32° – 120° F / 0° – 49° C)

non-condensing

x 29mm Thick

: 3.78” Diameter x 1.14” Thick / 96 mm Diameter

: 32° – 122° F / 0° – 50° C (Agency

: 95% max. (Agency Compliance - 93% max.),

explosion and burns. Do not recharge, disassemble, heat above 212° F (100° C) or incinerate. Dispose of used batteries properly. Keep away from children.

FC: BATTERY CAUTION: Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212° F (100° C) or incinerate. Dispose of used batteries promptly. Keep away from children.

SP: BATTERY CAUTION: Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212° F (100° C) or incinerate. Dispose of used batteries promptly. Keep away from children.

PA: BATTERY CAUTION: Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212° F (100° C) or incinerate. Dispose of used batteries promptly. Keep away from children.

https://mywebtech.honeywell.com/

www.honeywell.com/security/hsc/resources/wa

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules, and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS-210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une reception indésirable.

– The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.

séparation d'au moins 7,8 pouces (20 cm) de toutes les personnes.

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.

L'antenne (s) utilisée pour cet émetteur doit être installée à une distance de

MyWebTech

Warranty

800-15964 11/15 Rev B BETA2