5881EN-SOC-V1
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
USE MAX. OF 220 ft. (67m) OF #22 (0.64mm) WIRE
OR 550 ft. (168m) OF #18 (1mm) WIRE FOR EACH RUN.
20 ft. MAX. IN COMMERCIAL FIRE INSTALLATIONS.
(SEE RECEIVER'S INSTRUCTIONS).
THAT MAY CAUSE UNDESIRED OPERATION.
FCC ID CFS8DL5882AP
.
TO CONTROL'S KEYPAD
TERMINALS. EACH RECEIVER
YELLOW
RED
DIP SWITCH #5
MUST BE ON INDIVIDUAL
HOME RUN.
BLACK
GREEN
(SEE THE RECEIVER'S INSTRUCTIONS).
ON: FOR USE IN COMMERCIAL FIRE APPLICATIONS.
WIRING
OFF: USE IN NON-COMMERCIAL FIRE INSTALLATIONS.
DIP SWITCH: WHITE AREAS = SWITCH HANDLES
POSITION 2-4: DETERMINE RECEIVER'S ADDRESS
CONSULT CONTROL'S INSTRUCTIONS FOR ADDRESS TO USE.
PLUG & SOCKET
OPENING
01234567
3 ——ON ON ——ON ON
4 — ON — ON — ON — ON
5 (SEE TEXT ABOVE)
SWITCH RECEIVER ADDRESS SETTINGS
POSITION (“—” means “OFF”)
OFF
54321
DIP SWITCH BELOW SHOWN SET FOR ADDRESS "0".
ON
FRONT OF PC BOARD
BACK OF PC BOARD
DETAIL A
FRONT AND
REAR TAMPER
5881ENHC ONLY
SEE
DETAIL A
INDICATOR LED
INTERFERENCE
MUST BE IN OFF POSITION
2 ————ON ON ON ON
1
INSERT IN
ANTENNAS
TERMINALS
RIGHT-HAND
GREEN LED: NORMALLY OFF
ONE SHORT FLASH - RF MESSAGE DECODED
ONE LONGER FLASH - COMMAND RECEIVED FROM CONTROL
NOTES:
WHEN AN ENCRYPTED TRANSMITTER IS SUCCESSFULLY ENROLLED,
LED FLASHES A NUMBER OF TIMES THAT IS EQUAL TO THE SPACE
AVAILABLE FOR ADDITIONAL ENCRYPTED KEYS.
THE GREEN LED IS ALSO USED WHEN CHECKING ENCRYPTED KEY
SPACE AVAILABLE AND PERFORMING DELETIONS. SEE ENCRYPTED
BOARD
CIRCUIT
DIP SWITCH
KEYS DESCRIPTION FOR DETAILS.
HOLES
MOUNTING
5881ENL
5881ENH
BE INSERTED IN LEFT-
5881ENM
5881EN SERIES
5881ENHC
MUST
NOTE: WHEN CIRCUIT BOARD IS MOUNTED
IN CONTROL'S CABINET, GROUNDING LUGS
(2) PROVIDED
HAND TERMINALS OF ANTENNA BLOCKS
AND SECURED TO CABINET (SEE RECEIVER'S
AND CONTROL'S INSTRUCTIONS).
WHEN BOARD IS MOUNTED IN A SEPARATE
CABINET (COMMERCIAL FIRE APPLICATION),
DO NOT USE THE GROUNDING LUGS.
TO RELEASE CIRCUIT BOARD, BEND BACK
BOTTOM TABS (2). FOR COMMERCIAL FIRE
APPLICATION. USE TWO SCREWS
(NOT SUPPLIED) WITH INSULATING WASHERS
BENEATH THE HEADS. TO MOUNT BOARD IN
SEPARATE CABINET.
(SEE RECEIVER'S INSTRUCTIONS).
Figure 3: Summary of Connections, 5881EN Series RF Receivers
5
FCC ID CFS8DL5882AP
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your
information:
This equipment generates and uses radio frequenc y energy and if not installed and used properl y, that is, in strict acc ordance with the manufacturer's
instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B
computing device in accordance with the s pecifications in Part 15 of FCC Rules, which are designed to prov ide reasonable protection against such
interference in a residential installati on. However, there is no guarantee that interf erence will not occur in a part icular installation. If this equipment does
cause interference to radio or televis i on reception, which can be determined by turning the equipment off and on, the user is encouraged to try to c orrect
the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.
If necessary, the user should consul t the dealer or an experienced radio/t elevision technician for additional suggestions. The user or instal ler may find
the following booklet prepared by the Federal Communications Commission helpful:
This booklet is available under Stock No. 004-000-00450-7 from the U.S. Government Printing Office, Washington, DC 20402.
"Interference Handbook"
The user shall not make any changes or modifications to the equipment unless authorized by the Installation and Setup Guide or User Guide.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
WARNING
THE LIMITATIONS OF THIS WIRELESS ALARM SYSTEM
While this System is an advanced wireless security system, it does not offer guaranteed protection agains t burglary, fire or other emergency. A ny alarm
system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example:
• Intruders may gain access through unprotect ed openings or have the technical sophistication to bypass an alarm sensor or disc onnect an alarm
warning device.
• Intrusion detectors (e.g., passive infrared detectors), smoke detectors, and many other sensing devices will not work without power. Battery-operated
devices will not work without batteries, with dead batteries, or if the batteries are not put in properly. Devices powered solely by AC will not work if
their AC power supply is cut off for any reason, however briefly.
• Signals sent by wireless transmitters may be blocked or reflect ed by metal before they reach the alarm receiv er. Even if the signal path has been
recently checked during a weekly test, blockage can occur if a metal object is moved into the path.
• A user may not be able to reach a panic or emergency button quickly enough.
• While smoke detectors have played a key role in reduci ng residential fire deaths in the Unit ed States, t hey may not activate or prov ide early warni ng
for a variety of reasons in as many as 35% of all fires, according to data published by the Federal Emergency Management Agency. Some of the
reasons smoke detectors used in conj unction with this System may not work are as follows. Smoke detect ors may have been improperly installed and
positioned. Smoke detectors may not sense fires that start where smok e cannot reach the detectors, such as in chimneys, in walls, or roofs, or on the
other side of closed doors. Smoke detect ors also may not sense a fire on another level of a residence or building. A s econd floor detector, for
example, may not sense a first floor or basement fire. Finally, smoke detectors have sensing limi tations. No smoke detector can sense every kind of
fire every time. In general, detectors may not always warn about fires c aused by carelessness and safety hazards like smoking in bed, violent
explosions, escaping gas, improper storage of flamm able materials, overl oaded elect rical circui ts, chi ldren playing wi th matc hes, or arson. Depending
on the nature of the fire and/or location of the smoke det ectors, the detector, even if it operates as antic ipated, may not provide sufficient warning to
allow all occupants to escape in time to prevent injury or death.
• Pass ive Infrared Motion Detectors can only detect intrusion within the designed ranges as diagrammed in their installation m anual. Passive Infrared
Detectors do not provide volumetric area protection. They do create multiple beams of protecti on, and intrusion can only be detecte d i n unobst ructed
areas covered by those beams. They cannot detect motion or intrusion that takes place behind wal ls, ceilings, floors, cl osed doors, glass partitions,
glass doors, or windows. Mechanical tampering, mask ing, painting or spraying of any material on the mirrors, windows or any part of the optical
system can reduce their detection ability. Passive Infrared Detectors sense changes in temperature; however, as the ambient temperature of the
protected area approaches the temperature range of 90° to 105°F (32° to 40°C), the detection performance can decrease.
• Alarm warning devices such as sirens, bells or horns may not alert people or wake up sleepers if they are located on the other side of closed or partly
open doors. If warning devices are located on a dif ferent lev el of the residenc e from the bedroom s, then they are less li kely to wak en or alert people
inside the bedrooms. Even persons who are awake may not hear the warning if the alarm is muff led by noise from a stereo, radio, ai r conditioner or
other appliance, or by passing traffic. Finally, alarm warning devices, however loud, may not warn hearing-impaired people.
• Telephone lines needed to transmit alarm signals from a premis es to a central monit oring station m ay be out of serv ice or t emporarily out of service.
Telephone lines are also subject to compromise by sophisticated intruders.
• Even if the system responds to the emergency as intended, howev er, occ upants may have insufficient time to protect themselves from the emergency
situation. In the case of a monitored alarm system, authorities may not respond appropriately.
• This equipment, like other electrical devices, is subject to component failure. Even though this equipment is designed to last as lo ng as 2 0 ye ar s, th e
electronic components could fail at any time.
The most common cause of an alarm system not functioning when an intrusion or fire occurs is inadequate maint enance. This alarm system should be
tested weekly to make sure all sensors and transmitters are working properly. The security console (and remote keypad) shoul d be tested as well.
This system's wireless transmitt ers are designed to provide l ong battery l ife under normal operating c onditions. Longev ity of batteries m ay be as much
as 7 years, depending on the environment, usage, and the specific wireless device being used. External factors such as humidity, high or low
temperatures, as well as large s wings in temperature, may al l reduce the actual batt ery life in a given install ation. This wireless system, however, can
identify a true low battery situation, thus allowing time to arrange a change of battery to maintain protecti on for that given point within the system.
Installing an alarm system may make the owner eligible for a lower insurance rate, but an alarm system is not a substitute for insurance. Homeowners,
property owners and renters should continue to act prudently in protecting themselves and cont i nue to insure their lives and propert y.
We continue to develop new and improved protection devices. Users of alarm systems owe i t to themselves and their loved ones to learn about these
developments.
6