Page 1
User Guide
USER GUIDE
Version 1.0
WideyeTM XC1
Wireless Game Controller for XBOX
TM
Thank you for purchasing WideyeTM XC1 Wireless Game Controller for XBOXTM. With
advance wireless 2.4GHz Frequency Hopping radio frequency technology and superior
Lag-Free performance, you will be playing comfortably anywhere in the room while
maintaining complete control over your gaming experience. For safe operation of
this product, please read this guide and the instructions of your game system carefully
before use.
Package Contents
§ Wireless Game Controller x 1 unit
§ Base Unit Receiver x 1 unit
§ User Guide x 1 unit
§ Warranty Card x 1 unit
Figure 1
Base Unit
Wireless Game Controller
About your WideyeTM XC1
Your WideyeTM XC1 retail package contains a Controller and a Base Unit, as shown in
Figure 1
The functions of the buttons and LED of the Controller are illustrated in Figure 2.
Left Stick
D Pad
Back Button
Start Button
Y Button
X Button
B Button
A Button
w w w . w i d e y e . c o m . s g
Right Button
Expansion Slot
Expansion Slot
Link Button
Left Button
Battery Compartment
XBOX Connector
XA1 Slot
Registration
WideyeTM XC1 Wireless Game Controller is pre-registered in the factory for excellent
out-of-box experience. However, if you encounter interference during usage, please
follow the steps below to re-register the unit:
a. Ensure that the Controller is switched OFF before proceeding
b. Insert three (3) AA betteries into the battery compartment of the Controller
c. Hold the BACK and START buttons down simultaneously and switch the Controller
ON
d. The green LED shall blink, which indicates that the Controller has entered into
the registration mode
e. Hold the LINK button of the Base Unit down and insert the XBOXTM connector
into the console; release the LINK button after the insertion
f. When the Controller and Base Unit are linked, the Controllers LED will turn ON
for a while and turn OFF again
After the registration, this product is ready for use.
Controller Neutral Position Reset
If the Left or Right Button are pressed, or the Left or Right Stick are moved out of neutral position
when the power is turned ON, these positions will be set as the neutral position, causing incorrect
control during game play.
To reset the controller, release all buttons and sticks to allow them to return to the
correct neutral position, then turn the power of the Controller OFF and ON.
Figure 2
LED Indicator
Black Button
White Button
Right Stick
On/Off Switch
Power Saving Mode
If the Controller is not being used for 2.5 minutes, it will be partially turned off and
go into Sleep mode to conserve battery consumption. To wake up the Controller
from Sleep mode, simply press any of the buttons. If the Controller is not to be used
for a long period of time, it is advisable to remove the batteries from the battery
compartment.
Battery Life Indicator
If the installed batteries are weak, the LED will start to blink. Replace the batteries
immediately.
Cautions
§ Do not expose the WideyeTM XC1 Wireless Game Controller to high temperature,
high humidity or direct sun light
§ Do not use benzine, thinner or other chemicals to clean the product. If you wish
to clean the product, please use a soft dry cloth
§ Do not attempt to disassemble or modify the product
§ If you feel tired, or experience discomfort or pain in your hands or arms while
using this product, please stop immediately. If the condition persists, consult your
doctor
§ Do not operate this product in any other way except with your hands. Do not
bring the Controller close to your head, face or near the bones of any part of
your body
§ Do not use the vibrating function of this product if you have any ailment of the
bones, or joints of your hands and arms. This may aggravate the injuries
§ Avoid prolonged use of this product. Take a break in every 30 minutes
§ Do not insert the batteries wrongly
§ Misuse of batteries may cause them to leak or explode that may result in injuries
§ Keep this product out of reach from children under the age of three (3). This
product contains tiny components, which may cause choking if swallowed
§ If the product is hot or perform abnormally, stop using it immediately
FCC Information
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This equipment may not cause harmful interference
2) This equipment must accept any interference received including interference
that may cause undesired operation
Page 2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
FCC Caution: Any changes or modifications not expressly approved by the
This equipment complies with FCC radiation exposure limits set forth for
This transmitter must not be co-located or operating in conjunction with
not occur in a particular installation. If this equipment does cause harmful
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
-
party responsible for compliance could void the user's authority to operate
this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
an uncontrolled environment.
any other antenna or transmitter.
Page 3
Page 4
Loading...