Addonics Technologies ZBW-10LS2EU User Manual

Screw 2

Fan

Switch

USB Port

eSATA Port

Power
Connector

Power LED

Drive Activity LED

Eject Button

Screw 1

Addonics

T E C H N O L O G I E S

Zebra Blu Ray & DVD±R/RW Writer

with eSATA and USB interface

ZBW-10LS2EU

Enclosure Overview

Rear View

User’s Guide

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician

Hardware Installation

1. Connect the power adapter to the power connector located at the back of the
enclosure.

2. Connect the data cable using
a. eSATA connection

Note: You should have configured the eSATA host controller on your
system before you connect the writer. Once the eSATA host controller is
configured, do the following steps below.
Plug-in the eSATA cable to the eSATA port on the enclosure and
attached the other end to your eSATA host controller.

b. Or USB2.0 connection

Attach the USB cable to the USB port on the enclosure and in your
system.

3. Power ON the enclosure using the switch on the back panel. You should see

Blu-ray/ DVD­ROM Drive

Blu-ray/DVD­ROM Drive

Sample driver of
an eSATA host
controller

Blu-ray/ DVD-ROM
Drive

USB Driver

the Green Power LED on the front panel at the bottom right light up.

4. Go to Device Manager to check if your system detects the Blu Ray writer

via eSATA connection

via USB2.0 connection

5. The Blu-ray writer will also show up in My Computer.

Installing PowerDVD from CyberLink Hi-Def Suite CD

Place the CyberLink BD Drive Solution CD to the BD / DVD-ROM Drive.
Step 1. Click Install Now button.

Step 2. Select OK.
Step 3. Select Next.
Step 4. Select Yes.
Step 5. Select Next. (The CD key will automatically show up)

Step 6. Select Next.
Step 7. Select only “Cyberlink Power DVD” then click Next.
Step 8. Select Finish.