Addonics Technologies ST6ESA, ST4ESA, ST4US-B, ST4SAML, ST5X1PM User Manual

Addonics

T E C H N O L O G I E S

Storage Tower

ST4IDEU2, ST4SAML, ST5X1PM, ST5XHPM,

ST4US, ST4ESA, ST6ESA, ST5ESAIUS, STMPC, STBTO

ST4IDEU2-B, ST4SAML-B, ST5X1PM-B, ST5XHPM-B,

ST4US-B, ST4ESA-B, ST6ESA-B, ST5ESAIUS-B, STMPC-B

User’s Guide

Version 1.0

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interf erence by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician

Storage Tower Overview

Model: ST6ESA

Model: ST4US

ST5X1PM

Model: ST4IDEU2

Model:

Storage Tower Preparation

•

•

to secure the drives.

•

panel

Side

Side panel
screw
locations

Remove the side panel screws.

• Slide the side panel towards the backside then pull or lift to open.

• To remove the front face panels, unscrew 2 screws on opposite sides

of the 5 ¼” drive bay on the tower

This picture shows the storage tower without both the side panels and front

faceplate.

Sample Installation on the tower using IDE hard drives

IDE Drives

Screw Holes

IDE drives Mounting
Brackets

• Make sure that screws are placed for both sides of the mounting bracket

Front Face Plates

After installing the hard drive, attach the side panels back to the storage

tower.