Addonics Technologies ADSAIDE44 User Manual

Installation Guide

44-pin IDE Connector

SATA Power and

Data Connector

Master, Slave &

Cable Select

Jumpers

Pin 1 Marker

15-pin SATA Power &
7-pin Data Connector

Front View

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

2. Connect the converter board to the SATA connector of
the hard drive.

Jumper Settings

Master Slave Cable Select
Note: To set the SATA hard drive as a Master Device

1. Locate the SATA connector of your 2.5” SATA drive.

when connected to an IDE channel, you need to
short the top pins located on the converter by
placing a jumper. As a Slave Device short the
middle pins.

3. (Optional) Connect the IDE ribbon cable to the 44-pin
connector on the converter. The red edge of the ribbon
cable needs to line up to pin 1 marker of the 44-pin
connector. The other end of the ribbon cable will be
connected to your motherboard’s 44-pin IDE channel.

TECHNICAL SUPPORT

Email: http://www.addonics.com/sales/
Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)
Phone: [phone]
Email: http://www.addonics.com/support/ticketid/