Addonics Technologies ADIDEU2 User Manual

Installation Guide

Front View

USB Pin
Header

Back View

B-Type USB
Connector

ADDONICS TECHNOLOGIES

Model: ADIDEU2

4-Pin Floppy
Power Connector

3. Using the provided Y-power cable, connect the 4-pin
floppy connector to the power connector of the
converter. This will provide power to the converter.

4. At the other end of the Y-power cable is the 4-pin Molex
power connector that you connect to the hard drive.

IDE Connector

Note: It is required to set up the IDE hard drive you are

connecting to the converter as a MASTER device.

1. Locate the 40-pin IDE connector of your IDE drive.

4-pin Molex
Power Connector

40-pin IDE Connector

Master or Slave
Jumper Settings

2. Connect the converter board to the IDE connector of the
hard drive.

5. Now connect the B-type USB cable to the USB port on
the converter or use the USB pin header cable.

B-Type USB cable USB Pin Header

cable

TECHNICAL SUPPORT

Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)
Phone: [phone]
Email: http://www.addonics.com/support/query/