Addonics ZBW-10LS2EU-N User Manual

Addonics

TECHNOLOGIES

Zebra Blu Ray & DVD±R/RW Writer

with eSATA and USB interface

ZBW-10LS2EU-N

Enclosure Overview

Drive Activity LED

Rear View

Eject Button

Fan Switch USB Port

Power LED

Screw 2

Screw 1

User’s Guide

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician

Power
Connector

eSATA Port

Hardware Installation

1. Connect the power adapter to the power connector located at the back of the
enclosure.

2. Connect the data cable using
a. eSATA connection

Note: You should have configured the eSATA host controller on your
system before you connect the writer. Once the eSATA host controller is
configured, do the following steps below.
Plug-in the eSATA cable to the eSATA port on the enclosure and
attached the other end to your eSATA host controller.

b. Or USB2.0 connection

Attach the USB cable to the USB port on the enclosure and in your
system.

3. Power ON the enclosure using the switch on the back panel. You should see
the Green Power LED on the front panel at the bottom right light up.

4. Go to Device Manager to check if your system detects the Blu Ray writer
via eSATA connection

Blu-ray/DVD­ROM Drive

Sample driver of
an eSATA host
controller

via USB2.0 connection

Blu-ray/ DVD-ROM
Drive

USB Driver

5. The Blu-ray writer will also show up in My Computer.

Blu-ray/ DVD­ROM Drive

Technical Support

If you need assistance to get your unit functioning properly, please call Addonics
Technical Support. Our technical staff will be happy to assist you, but they will
need your help to do so. Calling the technical support staff without all the proper
information can be both time consuming and frustrating. Here are some tips to
help you out:

MODEL NUMBER – Please have this number on hand.

SYSTEM INFORMATION – Type of computer, peripherals, etc.
OPERATING SYSTEM – What version of Windows
WHAT’S THE TROUBLE? – Give enough information

about your problem so that we can recreate and diagnose it.

FREE Software Drivers for all Addonics Technologies
Products are available 24 hours per day at the
World Wide Web Site: www.addonics.com

Contact Information

Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

TECHNICAL SUPPORT

Phone: [phone]
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/

`