Page 1
ADDONICS TECHNOLOGIES
Model: UFMDU
Note: Make sure that the capacity of the target card is equal or
larger than the source card.
For example, on the label of the card, it might identify both cards
as 8GB but the actual size differs. When these type of cards are
used on the Universal Flash Media duplicator, when you start
duplicating, you will receive a “Target Not Ready” error. To
resolve this issue, you need to decrease the card size of the
source card. To do this, navigate to: 6.Setup > 6.2Copy Size and
use the button arrows to decrease the card size of the source
card by increments of 1%.
I. Installing card into the Universal Flash Media Duplicator
IV. Duplicating a card
When the duplicator powers on, it initializes and goes through the
steps below
Shows the firmware version Initialize SDRAM's status..
Duplicator Panel
Source Bay
Target Bay
Source and target
flash reader LED
Power Switch
Duplicator Power
LED
Step 1
Insert the Source card into the source bay.
Note: Only one type of source card can inserted on the
source bay at a time.
Step 2
Insert the Target card into the target bay.
Note: Only one type of target card can inserted on the
source bay at a time.
II. Connecting the power cable and powering on
a. Connect the power cord provided from the wall outlet to the
back of the tower.
b. Push the power switch button to turn on the HDD duplicator.
III. The Duplicator Panel
There are four buttons and an LCD on the panel of HDD
Duplicator.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.
Detect Drives' status. Shows the first function:
Copy HDD copies data directly from the source card to the target
card.
Verify that the power LEDs of the flash reader light up.
Press ENT button to begin copy. The system will auto-detect the
card and show the following info on the LCD.
Verify that the power LEDs of the flash reader are blinking
indicating drive activity.
The LCD will show the following info during the copying process:
remaining time, completed percentage. The copy speed, capacity
and time will vary depending on the source hard disk. Once the
copying process is complete the LCD will display the following
results.
The complete user manual of the HDD Duplicator Panel can
found in the Driver Disk under User Guides or can be
downloaded from
http://www.addonics.com/support/user_guides/
Technical Support
Contact Information
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
TECHNICAL SUPPORT
Phone: 408-453-6212
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/
Loading...