Addonics RT93DAHXML User Manual
T E C H N O L O G I E S
User Guide
RAID Tower IX
(RT93DAHX / RT93DAHXML)
www.addonics.com
v3.1.11
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
Removing Cover of RAID
Tower IX
Loosen the 5 screws at the back of the
tower using a Philips screwdriver by
turning counter-clockwise. Separate the
metal casing of the tower from the housing
by lifting up the casing.
Installing drives into the
RAID Tower V
Step 1
Use a Philips screwdriver to secure the
3.5” SATA hard drive to the drive tray
RT93DAHX RT93DAHXML
Screws Screws
eSATA Ports Multilane Port
Step 2
Slide the tray into the Disk Array drive bay.
Note: It is recommended to fill up the RAID
Tower IX with SATA drives from top to
bottom. This is to help in identifying which
drives connects to which ports for easier
troubleshooting.
Note: The 5 port HPMXA system version
PCB board is mounted inside the RAID
tower and is connected to the multilane
bridge that is mounted at the back of the
RAID tower.
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
RAID Setting Button
Dip Switch
SATA Host Port (Port 5)
SATA Port 2
SATA Port 1
Floppy
Power
Connector
SATA Port 0
SATA Port 3
SATA Port 4
Drive activity LED Jumper Block (J1)
Error LED Jumper Block (J3)
Dip Switch Settings
Raid Mode 1 2 3 4 5
Individual Drive
(Factory Default)
0
1
3
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
5
Clone
Large
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
OFF
OFF
OFF
Enable
ERR Buzzer
Function
OFF
OFF
OFF
AutoRebuilding
to Spare
Drive
ON
OFF
ON
Port Multiplier Mode
OFF
ON
OFF
ON
ON
ON
Loading...