Addonics HDUSAS User Manual

ADDONICS TECHNOLOGIES

Model: HDUSAS

I. HDD Duplicator Overview

Note: Make sure that the capacity of the target hard disk is
equal or larger than the source hard disk.

4-pin floppy
power connector

Source
SATA port

Destination
SATA port

III. Duplicating a drive

When the duplicator powers on, it initializes and goes through the
steps below

Shows the firmware version

HDD Duplicator
Management Console

Step 1

Connect the Source drive into the source SATA port at the back
of the HDD Duplicator.

Step 2

Connect the Target drive into the target SATA port at the back of
the HDD Duplicator.

Step 3

Connect a 4-pin floppy power cable from the power supply to the
4-pin floppy power connector on the HDD Duplicator.

Sample Connection Diagram

Destination drive
(black port on
Duplicator console)

Source drive
(blue port on
Duplicator console)

II. The Duplicator Panel

There are four buttons and an LCD on the panel of HDD
Duplicator.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.

Initialize SDRAM's status..

Detect Drives' status.

Shows the first function: Copy HDD.

Copy HDD copies data directly from the source hard disk to the
target hard disk.

Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.

The LCD will show the following info during the copying process:
remaining time, completed percentage. The copy speed, capacity
and time will vary depending on the source hard disk. Once the
copying process is complete the LCD will display the following
results.

The complete user manual of the HDD Duplicator Panel can
found in the Driver Disk under User Guides or can be
downloaded from

http://www.addonics.com/support/user_guides/

Technical Support
Contact Information

Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

TECHNICAL SUPPORT

Phone: [phone]
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/