Addonics HDUS525 User Manual

ADDONICS TECHNOLOGIES

Model: HDUS525

I. Installing drive into the HDD Duplicator

Note: Make sure that the capacities of the target hard disks
are equal or larger than the source hard disk.

For example, on the label of the hard drives, it might identify both
drives as 80GB but the actual size differs. And when this type of
drives are used on the HDD duplicator, when you start
duplicating, you will receive a “Target Not Ready” error. To
resolve this issue, you need to decrease the drive size of the
source drive. To do this, navigate to: 8.Setup > 8.2Copy Size and
use the button arrows to decrease the drive size of the source
drive by increments of 1%.

IV. Duplicating a drive

When the duplicator powers on, it initializes and goes through the
steps below

Shows the firmware version

Initialize SDRAM's status..

Detect Drives' status.

Duplicator Panel

Source Drive Bay
Target Drive Bays

Step 1

Push the slide switch of the drive door gently from left to right to
open the source drive door (top bay) and slide in the 2.5” SATA
hard disk Source drive into the drive bay. Close the front panel.

Step 2

Push the slide switch of the drive door gently from left to right to
open the target drive door and slide in the 2.5” SATA hard disk

Target drive into the drive bay. Close the front panel.
II. Connecting the power cable and powering on

Power Switch

a. Connect the power cord provided from the wall outlet to the

back of the HDD Duplicator.

b. A power switch is located on the front of the tower. Push the

button to turn on the HDD duplicator.

III. The Duplicator Panel

There are four buttons and an LCD on the panel of HDD
Duplicator.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.

Shows the first function: Copy HDD.

Copy HDD copies data directly from the source hard disk to the
target hard disk.

Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.

The LCD will show the following info during the copying process:
remaining time, completed percentage. The copy speed, capacity
and time will vary depending on the source hard disk. Once the
copying process is complete the LCD will display the following
results.

The complete user manual of the HDD Duplicator can found in
the Driver Disk under User Guides or can be downloaded from

http://www.addonics.com/support/user_guides/

Technical Support
Contact Information

Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

TECHNICAL SUPPORT

Phone: [phone]
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/