Addonics HDUS3325DX User Manual

ADDONICS TECHNOLOGIES

Model: HDUS3325DX

Note: Make sure that the capacity of the target hard disk is

equal or larger than the source hard disk.
For example, on the label of the hard drives, it might identify both
drives as 80GB but the actual size differs. And when this type of
drives are used on the HDD duplicator, when you start
duplicating, you will receive a “Target Not Ready” error. To
resolve this issue, you need to decrease the drive size of the
source drive. To do this, navigate to: 6.Setup > 6.2Copy Size and
use the button arrows to decrease the drive size of the source
drive by increments of 1%.

I. Installing drive into the HDD Duplicator

III. The Duplicator Panel

There are four buttons and an LCD on the panel of HDD
Duplicator.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.

Duplicator Panel

Source Drive Bay
Target Drive Bay1

Target Drive Bay2

Target Drive Bay3

Power Switch

Step 1

Open the source drive door and slide in the 3.5” SATA hard disk
Source drive into the drive bay. Close the front panel and using
the key provided, turn the key lock to the Lock position. This will
secure the drive and turn on the power to the hard drive.

Step 2

Open the target drive door(s) and
slide in the 3.5” SATA hard disk
Target drive(s) into the drive bay.
Close the front panel and using the
key provided, turn the key lock to
the Lock position. This will secure
the drive and turn on the power to
the hard drive.

Note: Refer to the Snap-In 25 user guide for 2.5” SATA hard
drive installation on the HSUS3325DX.

II. Connecting the power cable and powering on

a. Connect the power cord provided from the wall outlet to the

back of the tower.

b. A main power switch is located at the back of the tower. Turn

the switch on. Another auxiliary switch is located on the front
of the tower.

c. Push the auxiliar y switch butt on to turn on the HDD

duplicator.

IV. Duplicating a drive

When the duplicator powers on, it initializes and goes through the
steps below

Shows the firmware version Initialize SDRAM's status..

Detect Drives' status. Shows the first function:

Copy HDD copies data directly from the source hard disk to the
target hard disk.

Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.

The LCD will show the following info during the copying process:
remaining time, completed percentage. The copy speed, capacity
and time will vary depending on the source hard disk. Once the
copying process is complete the LCD will display the following
results.

The complete user manual of the HDD Duplicator Panel can
found in the Driver Disk under User Guides or can be
downloaded from

http://www.addonics.com/support/user_guides/

Technical Support
Contact Information

Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

TECHNICAL SUPPORT

Phone: [phone]
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/