Addonics HDU5SAS User Manual

Addonics

The Panel
There are four buttons and an LCD on the panel of DVD Duplicator.

1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.

T E C H N O L O G I E S

HDD Duplicator Panel

HDU5SAS

Functions

The HDD Duplicator has 6 functions in total.

User’s Guide

Technical Support

If you need assistance to get your unit functioning properly, please call Addonics Technical
Support. Our technical staff will be happy to assist you, but they will need your help to do
so. Calling the technical support staff without all the proper information can be both time
consuming and frustrating. Here are some tips to help you out:

Contact Information
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

TECHNICAL SUPPORT

Phone: [phone]
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/

In Function 8, there are 13 subfunctions.

2 Async Copy HDD
Async Copy HDD informs user if one of the target drives has a smaller capacity
than the source drive.

Choose option 2 from the menu:

1 Copy HDD

Copy HDD copies data directly from the source hard disk to the target hard disk.

Make sure that the capacity of the target hard disk is equal or larger than
the source hard disk.

Choose option 1 from the menu:

Press ENT. Before the start of the duplication, the duplicator inspects all the
target drives and determines which has less capacity than source, then the LCD
will show the corresponding channel number.

And then automatically copies. The LCD will display the following info.

Once the copying process is complete the LCD will display the following results.

3 Compare

Compare HDD is used to see if the data on a source hard disk is identical to the
target hard disk after the Copy HDD operation.
Choose option 2 from the menu:

Press ENT to begin the comparison. The LCD will display the following info

Once the comparison is complete the LCD will display the following info as well
as the amount of data on the source hard disk.

Press ENT to begin copy. The system will auto-detect the hard disks and show
the following info on the LCD.

The LCD will show the following info during the copying process: remaining time,
completed percentage. The copy speed, capacity and time will vary depending
on the source hard disk. Once the copying process is complete the LCD will
display the following results.

4 Async Compare

Async Compare is used to see if the data on a source hard disk is identical to the
target hard disk after the Copy HDD operation.

Choose option 4 from the menu:

Press ENT to begin the async comparison. The LCD will display the following
info.