Addonics AE25SNSP INSTALLATION GUIDE

ADDONICS TECHNOLOGIES

Model: AE25SNSP

Mounting holes

Locking Mechanism

Drive door swings open to
accommodate a 2.5” SATA drive

SATA
connection

Cable Connections:

1. A SATA power & data Y-cable is provided with the 2.5”
Snap-in SP. Connect this cable to the SATA connection
at the back of the bay.

2. The SATA power & data Y-cable has a third connector.
Attached this connector to the power and drive activity
LED connector as labeled above.

If this connector is not connected, the power & drive
activity LEDs located on the front of the 2.5” Snap-in SP
will not function.

3. Connect the SATA data cable to a SATA port on your

system.

Power and drive
activity LED

Power and drive
activity LED connector

2.5” Snap-in SP installation:

1. Slide the 2.5” Snap-in SP into 3.5” drive bay.

2. Secure the 2.5” Snap-in SP by screwing it onto the 3.5”
drive bay.

TECHNICAL SUPPORT

Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)
Phone: [phone]
Email: http://www.addonics.com/support/query/