Addictive Desert Designs Stealth Fighter Front Bumper User Manual

Addictive Desert Designs

2007 – 2013 Jeep JK

Stealth Fighter Front Bumper

Installation instructions

PREPARATION STEPS

1. Set emergency brake.

2. You will need the following tools:
a. 3/4” socket
b. 7/16” socket
c. 5/8” wrench
d. 5/8” socket
e. 9/16” wrench
f. 7/32 allen wrench
g. 3/4" wrench
h. 19mm socket
i. ratchet or air gun

Note: This installation requires 2 people for best results

3. Included in Kit:
a. Stealth Fighter Front Bumper

i. Center Piece

ii. Side Pods

iii. Light Bar Hoop (light bar sold separately)

b. Hardware Kit

INSTALLATION INSTRUCTIONS

1. Remove stock bumper.

2. Install winch fair lead onto the new ADD bumper.
a. Use a 19mm socket

3. Now you will want to bolt your top light bar hoop onto you’re A.D.D Stealth Fighter bumper.

4. Next you will install your 20” light bar to the new A.D.D bumper. If you did not purchase the

light bar you can move on to next step. (light bar sold separately)

5. Now you will place the main center piece on your Jeep. You will want to place the top bolts on

each side to hold in place. Once they are in, now put the bottom two in and tighten your top
bolts. See the access holes below.