Addictive Desert Designs RAM 2500 5 User Manual

Addictive Desert Designs

2010 - Current Dodge RAM 2500

54” radius bar roof mount
Installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:
a. Drill
b. 1/4” Drill Bit
c. 1/4” Rivets (6)
d. Tape Measure

Note: This installation requires 2 people for best results

3. Included in Kit:
a. Right Mount(1)
b. Left Mount(1)

INSTALLATION INSTRUCTIONS

1. Mount light bar into both Roof Mounts to create an assembly.

2. Carefully remove the weather strip from the door Jams.

3. Carefully measure mount locations by measuring 17 1/8" from lower pillar at Fender to bottom

of mount at the location shown below. Do this for both sides of the truck.