Addictive Desert Designs Excursion Radius Bar Roof Mount User Manual

Addictive Desert Designs

1999 – 2014 ford superduty and

excursion radius bar roof mount

installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:
a. Drill
b. 1/4” Drill Bit
c. 1/4” Rivets (6)
d. Tape Measure

Note: This installation requires 2 people for best results

3. Included in Kit:
a. Right Mount(1)
b. Left Mount(1)

INSTALLATION INSTRUCTIONS

1. Mount light bar into both Roof Mounts to create an assembly.

2. Carefully remove the weatherstrip from the door Jams.

3. Carefully measure mount locations by measuring 20" from lower pillar at Fender to bottom of

mount at the location shown below. Do this for both sides of the truck.