Adder RMK12 Users Guide

(see over for RMK17)
1 Install the empty rack mount into your 19” rack frame and fully secure it.
2 Place a compatible module into each side of the rack mount so that their rear
panels butt up against the small pegs located on each of the side walls.
3 Locate the supplied thumbscrew and spacer.
4 Insert the thumbscrew through the spacer; then insert into the
small hole at the end of the center divider (A).
5 Gently tighten the thumbscrew so that the
spacer engages with the inner edges of the two modules and holds them in place (B).
6 Place the power adapters in the rear section
of the rack mount and connect them to their respective modules.
7 Make all other necessary connections to the modules.
(A)
(B)
AdderLink
4 0 0 0
1
2
3
4
Rack Mount: RMK12, RMK17
Quick Start
TRANSMIT
AdderLink
4 0 0 0
1
2
TRANSMIT
3
4
Using a blanking plate when a single module is installed
In order to maintain suitable cooling airow, if a single module is installed within the rack mount, you are recommended to install an optional blanking plate: RMK12-BP
Note: The outer edge of the blanking plate needs to overlap the ears of the rack mount itself, so you need to either install the blanking plate before the tray is installed or briey remove the mounting bolts on the blanked side (while supporting the
weight of the tray) to allow the blanking plate to be put in place.
RMK12-BP blanking plate
2 0 0 0
1
AUX
Using the RMK17 Adder rack mount
(see over for RMK12)
1 Install the empty rack mount into your 19” rack frame and fully secure it.
2 Place compatible modules into the three bays of the rack mount so that their rear panels butt up
against the small pegs located on each of the side walls.
3 Locate the supplied thumbscrews and spacers.
4 Insert the thumbscrew through the spacer; then insert into the small hole at the
end of a divider (A).
5 Gently tighten the thumbscrew so that the spacer engages with
the inner edges of the modules that are either side of the divider to hold them in place (B).
6 Repeat steps 4 and 5 for the other thumbscrew and
spacer.
7 Place the power adapters in the rear section of the rack
mount and connect them to their respective modules.
8 Make all other necessary connections to the modules.
(A)
(B)
AdderLink
2 0 0 0
1
AUX
2
1
Rack Mount: RMK12, RMK17
Quick Start
www.adder.com
AdderLink
2 0 0 0
1
AUX
2
1
AdderLink
2 0 0 0
1
AUX
2
1
Using a blanking plate when a single module is installed
In order to maintain suitable cooling airow, if only two modules are installed within the rack mount, you are recommended to install an optional blanking plate: RMK17-BP
Note: The outer edge of the blanking plate needs to overlap the ears of the rack mount itself, so you need to either install the blanking plate before the tray is installed or briey remove the mounting bolts on the blanked side (while supporting the weight of the tray) to allow the blanking
plate to be put in place.
RMK17-BP blanking plate
© 2021 Adder Technology Limited
All trademarks are acknowledged.
Part No. MAN-QS-000067_V1.0
Loading...