Adaptive Technologies PM-DA-G User Manual

PoleStar G-Series Dual Adapter
Installation Instructions PM-DA-48G
Important: This kit requires that mounted objects are of equal size and weight.
Thank you for choosing the PoleStar G-Series dual adapter kit. Used with the PM-24-6UP-G it creates a dual or a triple mounting system. Further, the dual adapter accommodates many standard speaker mounts, including yokes, U-brackets and pan and tilt mounts.
Important:
Mounting overhead systems require professional experience. Improperly installed equipment can result
in property damage, personal injury, death and/or liability to the installing contractor. Do not install if in
doubt about the integrity of the mounting structure.
Caution:
Due to the wide variety of mounting structures, environments, materials and mounting methods, the installing contractor must exercise good judgment in selecting the proper mounting area and hardware.
Follow these instructions for the most efficient and safest mounting results. Do not exceed the working load limit of 300lbs/136 kg.
Do not use Pneumatic tool to tighten bolts Apply Loctite solution to bolts and nylock nuts to prevent loosening over time before assembly
Bolt Torque: 35 to 40 foot pounds Package Contents:
1 pc PoleStar 2 pcs Hex bolt, ½-13 x 3.5” 2 pcs Hex bolt, ½-13 x 4.5” 4 pcs Fender washer, ½ x 2”OD 4 pcs Hex nylock nut, ½-13 4 pcs Split lock washer, ½, 4 pcs Flat washer, ½” SAE 2 pcs Hex bolt, ½-13 x 3” 2 pcs Rubber friction washer, 0.5x2.0x0.125 2 pcs Square Plastic End Caps 1 pc Locktite #262 5ml tube
Step1:
Apply Loctite solution to bolts and nylock nuts.
Step 2: Assemble Dual Adapter directly to Pole Adapter
Attach the dual adapter directly to the two upper holes or on the two holes below the extension arm of the pole mount using the included 3.5” long bolts, flat washers and nylock nuts. Check final horizontal alignment then tighten permanently (Figure 1 and Figure 2).
TM
Dual Adapter, G-Series
Figure 1
© 2011 Allen Products Company, Signal Hill, CA 90755 USA (562) 424-1100 REV00-100411
Step 3:
Attach pole mount and dual adapter assembly to the pole or column using the selected banding strap. See PM-BAND-
30, 60, 90 installation instructions. Step 4: Attach Mounts
Attach mounts (yoke mount, U-brackets, etc) to the ends of the dual adapter using the included bolts, split lock washer, fender washers, nylock nut and rubber friction gasket in between the yoke bracket and the dual adapter. Check final angle then tighten bolts permanently (Figure 3 for dual mount and figure 4 for triple mount application).
Step 5:
Attach speakers to U-Brackets/ yoke mounts. Refer to U­bracket or yoke mounts installation instructions (See main illustration).
Step 6: Install End Caps
After installation, cover the end of the dual adapter with the end caps. Trim end caps if necessary to clear bolts head and washers (Figure 3 and 4).
Step 7: Install Safety Cable
Secure a safety cable to the pole or column, and then attach the other end of the safety cable to the speaker to bypass the mounting system.
Figure 2
Figure 3
Figure 4
© 2011 Allen Products Company, Signal Hill, CA 90755 USA (562) 424-1100 REV00-100411
Loading...