Adaptive Technologies MM-120-BTM User Manual

MM-120-BTM
Universal Wall Mount Installation Instructions
The MultiMount™ MM-120-BTM wall mounting kit mounts and positions loudspeakers with bottom hole patterns weighing, up to 120 lbs/55 kg to most vertical structures. The MM-120-BTM simplifies and speeds up installations while offering a very versatile range of aiming.
Warning:
Mounting and/or rigging equipment requires experienced professionals.
Improperly installed loudspeakers can result in property damage, personal injury, death and/or liability to the installing contractor.
Note to installing contractor:
Due to the wide variety of wall structures, materials and mounting methods, these instructions assume that the installing contractor will exercise proper judgment in selecting the mounting area and hardware.
As a guide, the installation, when complete should be capable of supporting 5 to 10 times the actual applied load. Also, always use a back up safety system such as a safety cable.
To assure a trouble free installation, read through and follow these instructions carefully before beginning. If you have doubts about the integrity of the structure you are mounting to or you are not sure about the proper hardware to use, consult a structural and/or hardware specialist.
Be sure that all of the following items are included in this kit before proceeding:
Item #: Qty Description
1. 1 pc. Wall mounting plate
2. 1 pc. Speaker adapter assembly
3. 1 pc. Extension arm (attached)
Step 1:
If the optional Stud Brace Plate is selected to bridge the MultiMount-120-BTM between two structural wall studs, install this in the desired area now then bolt MultiMount-120­BTM directly to the bridge (Figure 2).
Step 2:
Detach the wall mounting plate from the support arm by removing the bolt, washers and nut securing the support arm to the wall mounting plate. Place the mounting plate over the signal wire exit and attach it to the wall with the appropriate hardware for the application. If in doubt, consult a local hardware specialist (Figure 3).
Four Mounting Points Three Mounting points
Figure 1 (Mounting Options)
© 2013 Allen Products Co., Inc. Signal Hill, CA 90755 (562) 424-1100 REV.00-102413
Step 3:
Mount the Wall Mount plate to the selected location using the optional stud brace plate or directly to the wall. Make sure that the wall is supported and able to support 5 times the weight of the speaker. Use a backing plate or plywood if necessary (Figure 1 and 4).
Step 4: Attach the adapter plate support arm assembly to the appropriate bottom mounting holes of the loudspeaker using the manufacturer’s suggested screws and washers. Tighten these fasteners permanently (Figure 5). If threaded mounting
points are not included in the speaker, consult the manufacturer for proper mounting procedures.
Figure 3
Figure 2
Step 5:
Lift speaker with the mount attached up to the wall mounting plate and insert the support arm into the tube of the wall mounting plate (Figure
6). Select which hole to use from the support arm then line up the support arm’s selected hole with the wall mounting plate’s hole and insert the 3/8” x 2 1/2” tap bolt. Permanently secure with 3/8” flat washer and nut (Figure 6).
Note:
If wiring is coming from the wall mount’s tube, feed the wire first to the support arm’s tube and out from its upper hole or at the end of the support arm, before inserting the support arm to the wall mount’s tube.
Figure 4
Step 6: Setting the pan angle
Rotate the speaker horizontally, right or left, until it is aimed in the desired direction. Permanently tighten the socket head screw at the support arm with a 5/16” hex wrench (Figure 7).
© 2004 Allen Products Co., Inc. Signal Hill, CA 90755 (562) 424-1100 Rev. 01-101408
Figure 5
Loading...
+ 1 hidden pages