ADAM elements SELFIE Quick Start Guide

Quick Start Guide

First step: Bluetooth pairing

Touch-hold the camera key for 3 seconds till the
blue light flashes to show that the Bluetooth is
turned on: pair up with“Dispho”and the blue light
will be on all the time if the pairing is successful.
Touch-hold the camera key for another 3 seconds
to shut Bluetooth down.

Camera button

Second step: open the phone holder

Set this product face up and turn the phone holder
in the back downward for 90° to open it. Then
rotate the holder 180°horizontally to face forward.

Third Step: Fix the phone

Rotate the phone holder till you can pull open the
holder handle and fix the phone securely on the holder.

Fourth Step: Photograph

Set the volume button on your phone to act as the
shutter button.
Use the remote control to take a photo.

Fifth Step: Use tripod

This product comes with a tripod. Open the selfie
holder from the bottom and fix it on a steady
horizontal plane, then you can start to enjoy your
selfie shooting experience.

Separated Bluetooth remote control is designed to be
separable with a Bluetooth range of 10 meters.
The bottom of the remote control is equipped with a charging
port; please use it to charge this product.

is device complies with Part 15 of the FCC Rules. Operation is

Th
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.