Adam S1A User Manual [en, de]

ADAM - Studio Monitor
English / Deutsch
of 12
ADAM Studio Monitors are built to a maximum in reproduction quality and
following hints and considerations, as the positioning and the acoustical pro-
The speakers should be positioned on  rm ground or a stand. Vibrating parts
of 12
You will lose room information!
Not so:
the speaker completely.
which will „smear“ the sound in time.
Tweeter should be positioned approximately at the height of your ears.
When you start listening keep all panel settings in their original linear position.
You should listen to various recordings  rst, especially untreated material, that
tion has been applied. After some experience you will be better prepared to
Transportation
the original packaging materials as experience shows that it is very dif cult to avoid
We very much hope that you enjoy your new monitors and their unique transducer
The ADAM people.
of 12
The Back Panel
The Back Panel Controls allow the speaker to be adapted to different listening and
Shelve Filter with 6 kHz cut off frequency
Shelve Filter with 150 Hz cut off frequency
We deliver the speakers with all controls set to the  at position.
To adapt to different signal levels, the voltage that is needed to drive the unit to its
of 12
A more detailed possibility to optimize the reproduction are the two shelve  lters
the amplitude is progressively changed. The given dB values occur at 20 Hz and
The voltage gain of the tweeter ampli er and thus the complete tweeter level can
ADAM - Studio Monitor
Audio GmbH
fon:
fax:
e-mail:
web:
www.adam-audio.com
≤1,5 %
≥103 dB/W/m
Woofer
Voice coil ø
Voice coil length
A.R.T. Tweeter
Tweeter gain:
General
Amp Woofer channel *1,*2
Amp Tweeter channel *1,*2
THD >80 Hz
Weight
Width/Height/Depth
Warranty
S1A
Deutsch
von 12
ADAM Studio Monitore werden mit dem Ziel größtmöglicher Perfektion und
Wiedergabequalität entwickelt und gebaut. Damit sich die Fähigkeiten Ihrer
Tips und Überlegungen, denn die Aufstellung im Raum sowie die Eigenschaf-
ten des Hörraums sind von größerer Bedeutung für das Gesamtergebnis als
Aufstellung senkrecht:
Aufstellung waagerecht:
von 12
Sie verlieren bei dieser Anordnung in der Wiedergabe an Räumlichkeit und
Ortbarkeit der Schallquellen.
Weiter gilt:
Abstände zu den Seitenwänden wenigstens 40 cm, um qualitätsmindernde „early
Transport
Verpackungsmaßnahmen herrühren, können wir leider nicht aufkommen.
Viel Spaß ...
Wir wünschen Ihnen nun viel Freude beim Hören Ihrer Lautsprecher. Wenn Sie
Wir helfen gerne.
Nicht so:
von 12
Werksseitig werden alle Regler auf neutrale Positionen eingestellt.
von 12
Änderung des Klangcharakters dar und sollte mit Vorsicht benutzt werden. In Fällen
ADAM - Studio Monitor
Audio GmbH
fon:
fax:
e-mail:
web:
www.adam-audio.com
Tieftöner
Anzahl
A.R.T. Hochtöner
Anzahl
Allgemeines
Tieftöner (1/2)*
THD >80 Hz
Technische Änderungen bleiben vorbehalten
S1A
≤1,5 %
≥103 dB/W/m
Loading...