inbay® 3 coils universal 15W
part-no.: 240000-01-043
D
EINBAUANLEITUNG
GB
INSTALLATION GUIDE
level of difficultySchwierigkeitsgrad
gering hoch low high
Product Mode EPP 15W fixed frequency 127,75 kHz
Input Voltage
Inrush Current
Input Current (min/max)
9-16V (DC
)
20A (peak 25ns) (DC
0,06-1,7A (DC
)
)
Average standby current 23mA
Output Voltage (V
Output Current (I
Sachgemäße Installation unter Beachtung dieser Einbauanleitung erforderlich. Achten Sie auf korrek te Anschlüsse. Verlegen Sie die Kabel so, dass
Sie weder geknickt, gequetscht oder beschädigt werden können. Sorgen
Sie dafür, dass sich die Kabel nicht in Gegenständen verfangen können.
Wir können keine Haftung für Schäden übernehmen, welche durch unsachgemäße Installation oder Nutzung verursacht wurden. Verwenden Sie
darum ausschließlich das mitgelieferte Montagematerial.
Technische Änderungen vorbehalten, alle Angaben ohne Gewähr.
) VIN = Nom. 5V output (5W mode) 4,75V 5,0V 5,25V
OUT
= Nom. 9V output (10W mode) 8,55V 9,0V 9,45V
V
IN
= Nom. 9V output (15W mode) 8,55V 9,0V 9,45V
V
IN
) VIN = Nom. 5V output (5W mode) 0A 1,1A
OUT
= Nom. 9V output (10W mode) 0A 1,2A
V
IN
= Nom. 9V output (15W mode) 0A 1,6A
V
IN
An appropriate installation in observance of these operating instructions
is necessary. Please make sure the wiring is arranged so it is not bended
or crimped due to the risk of cable break. Make sure that all connections
are correct. Route the cable away from moving parts, do not allow the
cable to be entangled, pinched or damaged in any way.
We will not be liable for damage due to improper installation or utilization.
Use the specified accessory parts to prevent product failure.
Subject to technical modifications; no responsibility is accepted for the
accuracy of this information.
Min Typ Max
Das „Qi“ Logo ist Warenzeichen des „Wireless Power Consortium“
The “Qi” symbol is a trademark of the “Wireless Power Consortium”
acv GmbH · Straßburger Allee 10-12 · D-41812 Erkelenz · GERMANY
v18052018
1
Einbauanleitung / Install Manual
installation area (sample)
panel
2
power supply
Measurements (mm)
Einbauanleitung / Install Manual
wireless
charging tray
Driver Seat
Knee 29 cm
passenger
FRONT
driver
Passenger Seat
FRONT
Knee 28 cm
passenger
REAR RIGHT
passenger
REAR MIDDLE
passenger
REAR LEFT
Leg 36 cm
Body 74 cm
Hand 45 cm
Arm 62 cm
Head 114 cm
Passenger Seat
REAR LEFT
Knee 98 cm
Leg 115 cm
Body 152 cm
Hand 124 cm
Arm 137 cm
Head 175 cm
Leg 35 cm
Body 75 cm
Hand 46 cm
Arm 61 cm
Head 115 cm
Passenger Seat
REAR MIDDLE
Knee 94 cm
Leg 110 cm
Body 139 cm
Hand 116 cm
Arm 148 cm
Head 174 cm
Passenger Seat
REAR RIGHT
Knee 97 cm
Leg 113 cm
Body 155 cm
Hand 120 cm
Arm 139 cm
Head 172 cm
4
EU decleration of conformity
Hereby, acv GmbH declares that the radio equipment 240000-01-043 is in compliance with directive
2014/53/EU. The full text oft he EU decleration of conformity is available at the following internet address:
https://www.acvbmbh.de/
FCC Part 15 Compliance Statement
This device complies with Part 15 of the FCC Rules.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the product.
NOTE: This equipment has been tested and found to comply with the limits for a wireless power transfer,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Compliance
This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the device & your body.
ISED Regulatory Compliance
This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
L’appareil ne doit pas produire de brouillage;
L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
6
Einbauanleitung / Install Manual
8
Loading...