SUPERIOR SERIES LIFTS
TABLE OF CONTENTS
1. New Construction Sleeve Anchor System
2. Retro Fit Sleeve Anchor Method
active forever
.com
FITNESS, SAFETY & MEDICAL SUPPLIES
SUPERIOR SERIES LIFTS
S-350
NEW CONSTRUCTION & SAW CUT SLEEVE ANCHORING METHOD
INSTALLATION MANUAL
SUPERIOR SERIES
S-350
SLEEVE ANCHORING SYSTEM INSTALLATION
PARTS LIST
1 - Anchor Sleeve w/ Base
1 - Bonding Lug w/ nut & bolt
1 - Plastic Cap
ANCHORING SLEEVE, BASE PLATE & BONDING LUG
S-350
ADA GUIDELINES FOR POOL LIFT PLACEMENT
•Pool Lift Location. Pool lifts shall be located where the water level does not exceed 48 inches (1220 mm).
Seat Location. In the raised position, the centerline of the seat shall be located over the deck and 16 inches (405 mm)
minimum from the edge of the pool. The deck surface between the centerline of the seat and the pool edge shall have a
slope not steeper than 1:48.
•Clear Deck Space. On the side of the seat opposite the water, a clear deck space shall be provided parallel with the seat.
The space shall be 36 inches (915 mm) wide minimum and shall extend forward 48 inches (1220 mm) minimum from a line located
12 inches (305 mm) behind the rear edge of the seat. The clear deck space shall have a slope not steeper than 1:48.
•Submerged Depth. The lift shall be designed so that the seat will submerge to a water depth of 18 inches (455 mm) minimum
below the stationary water level.
SUPERIOR SERIES – SLEEVE ANCHORING SYSTEM
Water
12” to 17” Distance From Water’s Edge (front edge of anchor sleeve)
Pool Wall
Actual application
3’
Overview
Anchor Sleeve
3’
Section Detail
3’
Anchor Sleeve
Cold Pin
Concrete
6”
Cold Pin
Bonding Lug
COMPACT SAND
Front of Anchor Sleeve must be 12” to 17” from the water’s edge
Optimal placement is 14”
Connect copper wire to the bonding lug and then to your bonding grid
Cold Pin’s should be ½” rebar 6” to 8” long
NOTE: Make sure your anchor sleeve is level and square with your pool’s edge.
Concrete
Step 1: Determine the location for installation (Make sure all ADA requirements are
met).
***NOTE: The installation of Global Lift Corp’s anchor system’s are a guideline of
minimum requirements. In some states or municipalities they may require additional
steps due to their local codes or ordinances.***
Step 2: Make sure that all the parts are present (Refer to the parts list)
1 - Anchor Sleeve w/ Base
1 - Bonding Lug
1 - Plastic Cap
Step 3: At the determined location for installation, chalk out a 3’ X 3’ area prior to
cutting out the concrete. (Refer to overview, the front end of the Anchor Sleeve
must be 12” to 17” from the water’s edge and 6” deep). New Construction, the
concrete must be 6” deep with a ½” reinforcing rod, minimum of an 18” grid.
NOTE: Make sure that all local codes and ordinances are met.
Step 4: Once the 3’ X 3’ area is cut out, make sure you drill in the inner wall of all 4
sides of the area (refer to the section detail) for the purpose of cold pinning the new
concrete to the old concrete. Use 1/2” rebar, 6” to 8” in length.
Step 5: Place the Anchor Sleeve in the cut out area, make sure that the front of the
Anchor Sleeve is 12” to 17” from the water’s edge. (refer to overview) A key element
is to make sure that the Anchor Sleeve is level and square with the pool so that your
Superior Series Lift sits properly on the deck.
Step 6: Bonding the unit – The bonding lug is supplied with the Anchor Sleeve locate
the bonding lug, connect the bonding lug to the bonding grid.
NOTE: Make sure that all local codes and ordinances are met.
Step 7: Pouring your concrete, (make sure you cover the hole on your anchor sleeve
with the plastic cap provided, so you don’t get concrete in the sleeve) a minimum of
4,000 psi concrete with reinforcing rod. Also make sure that the top of the anchor
sleeve is flush with the deck. Before you install your l
concrete set up for 48 hours.
ift make sure you let the
Step 8: After the concrete has set for 48 hours, now it’s time to install your lift. Place
your Superior Series Lift over the anchor sleeve, once you have completed the
installation, please refer to User’s Manual for a safe operation.
www.ActiveForever.com
Loading...