Activeforever EZ Access Suitcase Ramp Signature User Manual

INSTRUCTIONS FOR USE

Available in 2-, 3-, 4-, 5-, 6-, 7-, & 8-foot Lengths

Optional top lip extension is available. See below or contact your local EZ-ACCESS retailer for

details.

1. Maximum weight limit is 800 pounds.

2. Read and follow all instructions before use.

3. Do not use if ramp is damaged or unstable.

4. Ramp is shipped fully assembled.

5. Place ramp on landing in the folded position and ensure that the top
lip (labeled TOP) is resting securely on the landing (DIAGRAM 1).

6. Unfold ramp and center on landing (DIAGRAM 1 & 2).

7. SAFETY & MAINTENANCE: Regularly check ramp for damage, and
check and tighten any loose fasteners. Keep ramp surface clear of
ice, snow, dirt, leaves, and other debris. For snow/ice, remove
accumulation and sweep the surface clean. To remove dirt, leaves,
and other debris, sweeping the surface or using a garden hose will
usually suffice, but, if needed, use a damp cloth or soft brush with
non-alkaloid detergent and water. Rinse well and use extra caution
if ramp surface is wet.

8. OPTIONAL FEATURE: Increase the usefulness of the SUITCASE
Signature Series™ Ramp with the Top Lip Extension (TLE). This
optional extension increases the standard 3” lip to become 9”,
allowing the ramp to clear the rear bumper of SUVs and vans by
simply attaching to the top lip of th
use with unoccupied mobility equipment only and, when used,
reduces the overall ramp weight capacity to 500 pounds. Contact
your local retailer or visit www.ezaccess.com for details.

e ramp (diagram 4). TLE is for

®

WARNING: Ensure that the top lip is secure before using
ramp. We recommend attaching the ramp temporarily to the
landing using the provided clevis pins (drill 1/4” hole in
landing) or semi-permanently using screws through the pre­drilled holes at the top of each section (DIAGRAM 2). To
prevent ramp from becoming dislodged during use, ensure
that the top lip overlaps the resting surface as far as possible.

WARNING: The surface holding the top lip needs to be
substantial; make sure that the surface and supporting
structure is of sound construction.

WARNING: Ramp may be slippery when wet or icy.

WARNING: Use only with a qualified helper and always use

your lap belt.

WARNING: The ramp shown in diagrams (below) is the 5-ft
length. To select the ramp length, an incline chart is provided
on the reverse side of this document. However, it is intended
only as a guideline. Refer to your equipment's (wheelchair or
scooter) Owner Guide for the proper degree of incline/decline
and chair direction before attempting ramp use. Never exceed
its recommendations.

DIAGRAM 1 2 MARGAID 3 MARGAID

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

1. EZ-ACCESS, a division of Homecare Products, Inc., (herein referred to as Manufacturer), warrants that the equipment shall be free from defects in
material and workmanship under normal use and service for a period of 3-years from the date of original purchase. This limited warranty applies to the
original purchaser only and is non-transferable. This limited warranty is applicable to defective metal structure components only (excludes powder coated
finish, applied non-skid tread, etc.) No part of this warranty will apply to any equipment which has been subject to misuse, vandalism, negligence,
alteration, improper loads, accident, improper installation, or which has been repaired outside Manufacturer’s place of business in any way as in the reasonable judgme
Manufacturer, to adversely affect its performance and reliability, nor to normal deterioration due to wear, tear and exposure, corrosion, or damage caused by rain, fire,
earthquake or other natural causes or acts of nature.

2. Manufacturer’s obligation and purchaser’s sole remedy under this warranty is limited to, at Manufacturer’s option, repairing or replacing equipment which is returned to its
place of business and which, upon examination, shall disclose to Manufacturer’s reasonable satisfaction to have been defective. Manufacturer will make the repair or
replacement of defective components at its own expense. If Purchaser discovers a defect, he/she must call Manufacturer at 253-249-1101 to request a Return Au
(RA) to return the merchandise to Manufacturer.

3. If Manufacturer determines, in its sole discretion, to replace the equipment with either a new or repaired unit, purchaser shall be responsible for a charge prorated on the
following basis: The purchaser will be allowed a credit against the purchase price of equivalent equipment at the time of return to Manufacturer, in proportion to the
percentage of the warranted service life remaining at the time of such return. Purchaser will be responsible to pay the balance of the purchase price of equivalent equipment.
Manufacturer reserves the right to require payment prior to delivery of the repaired/replaced equipment. In calculating available credit, the remaining warranted service life
will

be rounded up or down to the nearest whole year. YEARS 0-1: Unit repaired or replaced; YEARS 1-2: Repair or 50% $ credit (current purchase price multiplied by credit
percentage); YEARS 2-3: Repair or 25% $ credit (current purchase price multiplied by credit percentage). This limited warranty does not cover removal or reinstallation.
Manufacturer reserves the right to require Purchaser to pay for all shipping charges (Government purchases exempt).

4. DISCLAIMER: THE WARRANTIES AND REMEDIES CONTAINED HEREIN ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESS,
IMPLIED OR STATUTORY, INCLUDING ANY LIABILITY ARISING UNDER ANY WARRANTY
STATUTORY OR OTHERWISE. HOWEVER, THAT IF ANY IMPLIED WARRANTY CANNOT BE DISCLAIMED IN ANY TERRITORY WHERE A PRODUCT IS SOLD, THE
DURATION OF SUCH IMPLIED WARRANTY IS LIMITED TO THE DURATION OF THE LIMITED WARRANTY DESCRIBED IN THE FIRST PARAGRAPH.

5. MANUFACTURER SHALL NOT BE LIABLE UNDER ANY CONTRACT, NEGLIGENCE, STRICT LIABILITY OR OTHER LEGAL OR EQUITABLE THEORY FOR ANY
DIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, RESULTING FROM THE USE, MISUSE OR INABILITY TO USE THE EQUIPMENT, OR ARISING
OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF MA
REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY IS REPLACEMENT OF THE DEFECTIVE OR NON-CONFORMING EQUIPMENT OR PART.
THE MAXIMUM LIABILITY OF MANUFACTURER UNDER THIS WARRANTY IS LIMITED TO THE PURCHASE PRICE OF THE EQUIPMENT COVERED BY THE
WARRANTY.

6. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives

NUFACTURER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,

nt of

thorization

you specific legal rights, and you may also have other rights which may vary from State to State. Manufacturer reserves the right to change or improve its products without
any obligation to change

or improve any Product previously manufactured by it.