Activeforever Corpak Clog Zapper for Feeding Tubes (Box of 10) User Manual

CORPAK

INSTRUCTIONS FOR NG AND J-TUBE USE

MedSystems

Pump Set

• Turn feeding pump OFF and close roller clamp on administration set.

NG Tube

CLOG ZAPPERCLOG ZAPPER

CLOG ZAPPER

ApplicatorApplicator

Applicator

1 0

10 cc syringe

1 0

• Fill syringe to 10 cc mark with water (7.1 cc).

Remove applicator from tube.

NG Tube

6 cc syringe

1 0

• Fill tube with a recommended initial dosage of 2-6 cc of the CLOG ZAPPER solution.

Fill syringe completely.

PLUG tube.

• Keep

patient if procedure must be repeated.

APPLICATOR

SYRINGE

and

together with

• If tubing cannot be ﬂushed, REPEAT steps #4. thru #8.

After tube clears . . .

• Di

spose per institution’ protocol

• an

ESUME

FEEDING.

• Alw

ays check with physician to

determine how many times the

process can be repeated.

CAUTION

Protective eyewear is strongly suggested. CLOG ZAPPER

•

can cause irritation if it gets in contact with the eyes.

STORAGE REQUIREMENTS

CLOG ZAPPER, once reconstituted, should be used

•

within 24 HOURS.

REFRIGERATE mixture while not in use.

•

INSTRUCTIONS FOR G-TUBE USE

Cut APPLICATOR at dot.

•

Discard excess tubing.

•

Place APPLICATOR into G-TUBE’s Administration Set port.

•

Continue with NG TUBE INSTRUCTIONS above.

•

INSTRUCTIONS FOR LOW PROFILE DEVICES

Place FEEDING SET into LOW PROFILE DEVICE following manufacturer’s instructions.

•

Place APPLICATOR into FEEDING SET.

•

Continue with NG TUBE INSTRUCTIONS above.

•

5840D 09-08