Active E36 Installation Instructions Manual

Page 1
Tools Needed:
WARNING: Do not use air tools on manifold nuts. Vibration will damage 02 sensors.
12 mm wrench 13 mm socket 13 mm wrench 14 mm wrench or socket 15 mm socket WD-40 or similar lubricant
E36 Track Pipe
Installation Instructions
1. Place car on lift and spray manifold nuts and rear muffler pipe bolt with WD-40.
2. Disconnect 02 sensor behind catalyst. Use a 12mm or 13mm socket or wrench to pull joint between rear muffler and catalyst.
3. Pull the six 15mm bolts holding down pipe to manifold. With someone holding up muffler system, or support stand in place, pull off rubber mounts. Remove system.
4. Fit new Track Pipe headers to manifold making sure gaskets are in place. Tighten bolts.
5. Tighten all bolts and replace rubber hangers.
Page 2
6. Plug on new simulators and tie strap to fuel lines (OBD2 CARS
AA TRACK PIPE SYSTEM IS DESIGNED FOR OFF ROAD USE AND RACING APPLICATION ONLY.
ONLY)
Loading...