ACTi Cube Camera on Tilted Wall Installation Guide
2013/12/06
Cube with Bundled
Removable Bracket
Mounting on a Tilted Wall
using the Bundled Bracket
Installation Guide
For Models:
D1x, E1x, TCM-4xxx
www.acti.com
Installation Guide
Table of Contents
Installation Procedures ..................................................... 3
Step 1: Mount the Camera ........................................................................ 3
Step 2: Install the Camera ......................................................................... 4
Step 3: Connect the Camera ..................................................................... 6
Step 4: Access the Camera Live View ..................................................... 7
Step 5: Adjust the Viewing Angle and Focus .......................................... 7
Appendix ............................................................................. 8
How to Access the Camera Live View ...................................................... 8
Safety Information ............................................................ 16
2
www.acti.com
Installation Guide
Installation Procedures
This Installation Guide describes the procedures in installing the camera on a flat surface using
the bundled bracket.
Step 1: Mount the Camera
The bracket can be mounted on a concrete or wooden surface. Select the location where you
want to mount the bracket.
1. Mark the location of the three (3) screw holes on the surface. Depending on the surface
material, it may be necessary to drill the holes and insert the plastic plugs.
2. Using a Phillips screwdriver, attach the three supplied screws to secure the bracket to the
wall.
3
www.acti.com
Installation Guide
Step 2: Install the Camera
1. Screw the camera to the bracket.
2. Position the camera to face the target view area.
4
www.acti.com
Installation Guide
3. Tighten the knob to fix the camera position.
5
www.acti.com
Installation Guide
Network
AC Power
Source
PoE Injector /
Switch
Power Cable
Ethernet Cable
Ethernet Cable
(Data + Power)
Ethernet Cable
(Data)
Camera
Step 3: Connect the Camera
To connect the camera, you need to prepare the following:
Power over Ethernet (PoE) supported injector or switch
Ethernet cables
1. Connect an Ethernet cable to the Ethernet port of the camera. Then route the cable to go
along the wall.
2. Connect the other end of the Ethernet cable to the PoE injector / switch.
3. Connect the PoE injector / switch and a PC to the same network. Sample network
illustration below.
6
Loading...