Acrox PRINTER001 User Manual
User’s Manual
Wireless Presenter with Laser
Pointer
Page 1
Regulatory Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Certication
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
•
receiver.
Page 2
•
Consult the dealer or an experienced radio/TV
technician for help.
Notice: Any changes or modications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Extension cables are not recommended, if used, they
must be shielded in order to comply with the emission
limits.
IC Certication
The term “IC” before the certication/registration
number only signies that the Industry Canada technical
specications were met.
Declaration of conformity
Hereby, SMK-LINK Electronics Corporation, declares
that this product is in compliance with the essential
requirements and other relevant provisions of Directive
1999/5/EC.
All trademarks and registered trademarks mentioned
in this document are the property of their respective
owners.
Features and specications are subject to change without
notice.
© 2008 SMK-LINK Electronics, Inc.
Page 3
System Requirements
Hardware: 1 available USB port
Operating System: Windows 2000, XP or Vista
Macintosh OS X or above (F5 SlideShow and Alt-Tab
Application Switch not supported)
Package Contents
Wireless 2.4 GHz presenter
•
Micro USB receiver dongle (stored inside
•
presenter)
2 x AAA batteries
•
User’s manual
•
Carrying case
•
Installing the Rechargeable
Batteries (Supplied)
Sliding the battery cover off
Page 4
Insert batteries to the correct
polarities
Open the battery compartment by pressing
•
down the cover latch and sliding the door off
the presenter.
Insert the two supplied AAA batteries
•
(included in the package) to the battery slots.
Make sure the positive (+) and negative
(-) ends of the batteries match the polarity
markings inside the battery compartment.
Close the battery cover back into position.
•
Connecting the Presenter to
the Computer
Retrieve the micro USB receiver
•
dongle from the built-in storage
located at the top-end of the presenter.
USB Receiver
Top View of the Presenter
Page 5
Loading...