Acrox OPWIRWMU08 User Manual

Page 1
2.4GHz Wireless Hi-Low Blue Trace Mouse w/Nano Receiver
USER'S GUIDE
Ver.:1.00
CAUTION: To use this product properly, please read the user's guide before installation
Page 2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 3
Functional Introduction
ON/OFF Switch
LED Indicator
Metallic Wheel
Right button
Connect Button
Left button
Nano Receiver
Hi-Low Button
Installing the batteries
Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover.
1’st 2’nd
Pull
AAA Battery
**Warning:
*Please insert the batteries with the correct position according to the instruction labeled in the mouse.
Page 4
Hi-Low Introduction
Nano
Push
The perfect design for notebook users. This ultra slim, super small mouse is ideal for on-the-go users, and can be used comfortably anywhere, any time
Hi position
Receiver
Low position
Setup the Connection between the Receiver and the Mouse
1. Insert the batteries into the mouse, then follow the steps below.
2. Push the trigger on the bottom of the mouse to reveal the hidden layer
Page 5
3. Push out the Nano Receiver in the back of mouse then plug into your
*Mouse Indicator
PC/Laptop.
4. If the mouse is not working, please put it into pairing mode.
5. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function).
6.The LED indicator on mouse flashes steadily when it is in pairing
mode and stops blinking when it is successfully paired with the receiver. The mouse’s LED indicator remains off afterwards.
7. When the batteries of the mouse is low, the Low Power indicator will
start to blink.
LED Indicator
Red LED is on 3 sec.
Power ON
Red LED Blinks 3 times
During Pairing
Low Battery Warning will blink 10 times when turn on.
Loading...