Acrox OPBTNAMU01 User Manual
Users Manual
Rechargeable Bluetooth
Notebook Mouse
Page 1
Regulatory Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Certication
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
•
receiver.
Page 2
Connect the equipment into an outlet on a circuit different
•
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
Notice: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Extension cables are not recommended, if used, they
must be shielded in order to comply with the emission
limits.
IC Certification
TThe term “IC” before the certification/registration
number only signifies that the Industry Canada technical
specifications were met.
Declaration of conformity
Hereby, SMK-LINK Electronics, Inc. declares that
this Bluetooth Rechargeable Notebook Mouse is in
compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
All trademarks and registered trademarks mentioned
in this document are the property of their respective
owners.
Features and specifications are subject to change without
notice.
Page 3
System Requirements
Hardware:
Bluetooth-enabled computer system;
•
1 available USB 1.1 or 2.0 port
•
Operating System:
Windows 2000, XP or Vista;
•
Mac OS 10.4.6+
•
Package Contents
Bluetooth notebook mouse
•
USB charging cable
•
2 x AAA rechargeable Ni-MH batteries
•
User’s manual
•
Carrying pouch
•
Installing the Rechargeable
Batteries (Supplied)
Page 4
_
+
+
_
Step 1: Place the mouse on a at surface
and remove the battery cover from the
top of the mouse by pressing the release
button located below the scroll wheel. The
mouse will automatically eject the battery
cover.
Step 2: Insert the two supplied AAA
rechargeable Ni-MH batteries (included
in the package) to the battery slots. Make
sure the positive (+) and negative (-)
ends of the batteries match the polarity
markings inside the battery compartment.
Step 3: Snap the battery cover back into
position.
Do not use any disposable or Alkaline
batteries in this mouse. Use only the
rechargeable Ni-MH batteries supplied
with this mouse. Should replacing
batteries become necessary use only rechargeable AAA
batteries. Do not mix new and old batteries in the
mouse.
Page 5
Charging the Batteries
• It’s recommended that you fully charge the
batteries before initial use; nevertheless it’s
ready for set up (see next step) anytime during charging.
• Plug the USB connector of the charge cable
(included in the box) into the computer’s
available USB port.
• Connect the mini-USB tip of the cable to
the mouse charge port located at the front
end of the mouse.
• The mouse scroll wheel glows indicating
the battery power is low and continues to
glow while the batteries are being charged.
Page 6
When fully charged the scroll wheel will
cease to glow.
• The initial charging process may take up to
8 hours. Subsequent recharge may require
less time depending on the level of residual
power of the batteries.
• The mouse is operational during charging; you can continue use the mouse while
charging it via the USB charge cable.
• You are now ready to set up the mouse to
work with your Bluetooth system. (Note:
it’s not necessary to wait for the batteries to
be fully charged before setting up Bluetooth
connection to your system.) Turn on the
power by sliding the on/off switch located
at the bottom of the mouse to the “on” position.
Make sure the computer’s power
management is set to disable
hibernation mode while the mouse is
being charged. (Go to Control Panel,
Power Options, select “Hibernate” from
the tabs and uncheck the box marked
“Enable Hibernation”.)
Page 7
Setting up Bluetooth Connection
Connect button
On/Off Switch
Optical Sensor
Before you can use Bluetooth devices for
the rst time you must connect your devices
through a standard discovery mode and pairing
process.
During the process, depending on the system
and the Bluetooth software used, it may ask
you whether you want to use a passkey; please
select “no passkey”.
The Bluetooth Rechargeable Notebook
Page 8
Loading...