Acrox MU27 Users Manual

2.4GHz Wireless BlueTrace Mouse
w/Nano Receiver

USER'S GUIDE

Ver.:1.00

CAUTION: To use this product properly, please read the user's guide before installing.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply w ith the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reas on able protection against harmful interf er en ce in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communication s.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate
this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

1

Functional Introduction

1. Left button

2. Right button 9. Win Key

3. Scrolling Wheel 10. Nano Receiver

4. Forward 11. Battery Cover

5. Backward 12. Connect Button

6. ZOOM Key 13. ON/OFF Switch

7. DPI Switch Key (LED Indicator)

8. Battery status LED Indicator

DPI Switch

The LED indicator under tilt wheel will light up when you plug the mouse
into the USB port. The brightness of the indicator indicates the DPI
setting in use. There are three different settings:

z Bright: 1600 DPI
z Dim: 1300 DPI
z No light: 800 DPI

The default setting is 800 DPI. You can easily switch between DPI
settings. In order to save power, the LED display will only last for 10
seconds.

2