Fanless Embedded Controller comes with
Intel Celeron M Processor
Copyright Notice
This document is copyrighted, 2008. All rights are reserved. The original manufacturer reserves the
right to make improvements to the products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or transmitted in any form or by any
means without the prior written permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However , the original manufacturer assumes no responsibility for its use, or for any infringements upon the rights of third parties that may result from its
use.
The material in this document is for product information only and is subject to change without notice.
While reasonable efforts have been made in the preparation of this document to assure it s accuracy ,
Acnodes assumes no liabilities resulting from errors or omissions in this document, or from the use of
the information contained herein.
Acnodes reserves the right to make changes in the product design without notice to its users.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
Acknowledgments
All other products' name or trademarks are properties of their respective owners.
oAward is a trademark of Award Software International, Inc.
oCompactFlash™ is a trademark of the Compact Flash Association.
oIntel®, Pentium® 4, and Celeron® D are trademarks of Intel® Corporation.
oMicrosoft Windows ® Corp. is a registered trademark of Microsoft
oPC/A T, PS/2, and VGA are trademarks of International Business Machines Corporation.
All other product names or trademarks are properties of their respective owners.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
Packing List
Before you begin operating your PC, please make sure that the following materials are enclosed:
z1FES-6905 Embedded Controller
z1Phoenix Power Connector
z2Wallmount Brackets
z1Audio Cable
z1Screw Package
z1CD-ROM for manual (in PDF format) and drivers
If any of these items should be missing or damaged, please contact
your distributor or sales representative immediately .
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
Safety & Warranty
1. Read these safety instructions carefully .
2. Keep this user's manual for later reference.
3. Disconnect this equipment from any AC outlet before cleaning. Do not use liquid or spray detergent s
for cleaning. Use a damp cloth.
4. For pluggable equipment, the power outlet must be installed near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity .
6. Put this equipment on a firm surface during installation. Dropping it or letting it fall could
causedamage.
7. The openings on the enclosure are for air convection. Protect the equipment from overheating. DO
NOT COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct before connecting the equipment to the power
outlet.
9. Position the power cord so that people cannot step on it. Do not place anything over the power cord.
10. All cautions and warnings on the equipment should be noted.
1 1. If the equipment is not used for a long time, disconnect it from the power source to avoid damage by
transient over-voltage.
12. Never pour any liquid into an opening. This could cause fire or electrical shock.
13. Never open the equipment. For safety reasons, only qualified service personnel should open the equip
ment.
14. If any of the following situations arises, get the equipment checked by service personnel:
a.The power cord or plug is damaged.
b.Liquid has penetrated into the equipment.
c.The equipment has been exposed to moisture.
d.The equipment does not work well, or you cannot get it to work according to the user's manual.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
e.The equipment has been dropped and damaged.
f.The equipment has obvious signs of breakage.
15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS BELOW -20°C (-4°F) OR ABOVE 60°C (140°F). IT MA Y DAMAGE THE EQUIPMENT.
FCC
This device complies with Part 15 FCC
Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference received including interference that may
cause undesired operation.
Caution:
There is a danger of explosion if the battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer's instructions and your local
government's recycling or disposal directives.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
1.1 Introduction
The FES-6905 Advanced Embedded Control system continues the FES design concept but focuses
on the fast expanding Machine Automation market. The FES-6905 can provide two PCI-Express
slots for expansion. Therefore FES-6905's expandable function, compact size combined with
fanless design and highly efficient heat conduction mechanism can fulfill any rugged technical application in industrial automation, factory control, test instrumentation and safety surveillance.
Outstanding Over-spec Design
Intel's® popular Celeron M processor with speeds of 600MHz to 1.5GHz combined with fanless
design and high performance is widely acceptable and dependable in this market. USB 2.0, Ethernet
and 4 Serial ports allow communication with diverse devices with a high transfer rate. Furthermore,
the FES-6905 can concurrently support three tiers of expansion interfaces - PCI and PCMCIA. These
interfaces are fully integrated within the FES series and allow an upgrade to their usefulness. It is a
leading-edge thermal and vibration design (up to 60 degree operation and 5G RMS vibration) and
also an innovation for Machine Automation in the IPC industry. FES-6905 plays a role in connecting
all subsystems in common applications. Acnodes not only enhances your competitive value but also
gives you an excellent solution for the future.
Strict Quality Control Process
Acnodes retains the perfect product design and management team. Our Quality Control through
multiple level experience and test has earned a good reputation in IPC field. Acnodes Corp's whole
product series are subjected to high-level standards, which make them our best guarantee and
assurance to customers. Excellent product quality will always be Acnodes's best advertisement.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
24-hour FAE System
Acnodes’s e-RMA and e-F AE 24-hour a day systems for all customers' prompt request was formally
launched in 2005. No matter if it is a holiday or weekend; we can handle all kinds of requests and
give you a satisfactory response in 10 days. Acnodes is proud of our quick service and professional teamwork to provide our customers with continual support.
Great design, great value and great service are hallmarks of the Acnodes FES series embedded
control PCs. There really is no other choice for your application than Acnodes if you want the best
performance and best value!
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
Fanless Embedded Controller comes with
Intel Celeron M Processor
1.3 Specifications
System
oCPU: Intel® Celeron® M Processor
oSystem Memory: DDR SODIMM x 1, Max. 1GB
oExpansion: PCI slot x 1; PC/104+ x 2
oVGA: VGA x 1
oKeyboard/Mouse: PS/2 Keyboard & Mouse
oEthernet: 10/100Base-TX RJ-45 Connector x 1
oSSD: CompactFlash™ slot x 1
oHard Disk Storage: 2.5" SATA/IDE HDD Bracket x 1 in system
oSerial Port: 3 x RS-232, 1 x RS-232/422/485
oAudio:Line-in / Line-out / MIC-in by an extension cable
oUSB: 4 USB 2.0 ports
oWatchdog T imer: Generates a time-out system reset, setting via software
oPower Supply:
1. DC Input -- Internal DC- DC Converter (Default) Input voltage:9V DC~30VDC
2. AC Input -- External Power Adapter (Optional) Input voltage: 100V AC ~240V AC @ 50 ~
60Hz
oSystem Control: Power on / off switch x 1; Reset button x 1
oIndicators: Power LED x 1; HDD active LED x 1
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com