Acme Engineering 3054 Installation Manual

Refrigerant Charging Systems

High Vacuum Pumps

Automatic Evacuation Systems

NEW—IMPROVED

• Longer Straps-fits most recovery cylinders

• Faster-acting thermostat

• Improved cord set

Model 3054 (230V)

Refrigerant Cylinder Heater

Specialty Fittings and Couplers

Vacuum Gauges and Controllers

High Vacuum Sealant

Custom Products

and more..........

Fig. 1 Euro Plug (230V)

Instructions

Airserco Manufacturing Company
7555 Tyler Boulevard
Mentor, OH 44060 U.S.A.
[phone] Fax: [phone]
e-mail: [e-mail]
www.airserco.com

Airserco Manufacturing Company

INSTRUCTIONS

This heater uses the 230V Euro plug (See Fig.

1), other plug options available upon request
with minimum order.

Wrap the heater around the cylinder. Using the
extra long Velcro straps, secure the heater to
the cylinder with the printed side out. It is
important that the heater fits tightly. Check to
make sure that the area behind the thermostat
which is molded near the edge of the heater is
making good contact with the surface of the
cylinder. The heater should be positioned near
the bottom of the cylinder to be most efficient.

After positioning the heater on the cylinder,

approximately 460C (1150F) and it will continue
to cycle on/off under the thermostatic control to
maintain the cylinder surface temperature at

0

C (1150F) to 550C (1300F).

46

DO NOT use the heater unattended. NEVER use
the heater in wet conditions or outdoors. DO
NOT attempt to take the heater apart or make
any modifrcations. The heater is engineered for
maximum performance and reliability. ALWAYS
inspect the cordset before each use to check for
loose or frayed wires and connections.

Airserco Manufacturing offers a complete line of
cylinder heaters for 30 lb. containers up to 2,000
lb. containers for all applications.

insert the plug into a 230 volt outlet. DO NOT
use outdoors, or in wet conditions, this may
result in electrical shock. When plugged in the
heater will automatically shut off when the
surface temperature of the cylinder reaches

0

approximately 55

C (1300F). While plugged in,
the heater will start again when the surface
temperature of the cylinder drops to

INDOOR USE ONLY