Page 1
ACLARA RF SYSTEMS
Former HEXAGRAM, Inc.
30400 Solon Road.
Solon, OH 44139
440-528-7200
June 14, 2011
Users Manual
FCC ID: LLB09002G
The LLB09002G has no user adjustment or controls and are installed by factories trained personnel at the
manufacturing facility .Aclara RF Systems, former Hexagram LLB09002G devices are shipped to the
customer in the sealed LLB09002G enclosures. Thus, NO operational access can be made in the field,
without breaking the factory sealed enclosure.
The FCC wants you to know….. This equipment has been tested and complies with Part 15 and Part 90
of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference. This equipment generates uses and can radiate radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, try to correct the interference by one or
more of the following measures: • Reorient or relocate the equipment. • Increase the separation distance
between the affected equipment and receiver. • Consult Aclara, Inc. for help. Any changes or
modifications to this equipment not expressly approved by the Aclara, Inc. could void the authorization to
operate the equipment.
FCC RF Exposure Guidelines Aclara’s low power RF devices and their antennas must be fixed-mounted
on indoor or outdoor permanent structure(s) providing a separation distance of at least 20 cm from all
persons during normal operation. This device is not designed (and it has no external connection) to
operate in conjunction with any other antennas or transmitters. No other operating instructions for
satisfying RF exposure compliance are needed. This unit has no user or installer serviceable parts, and
requires no field adjustment or calibration. Units are sealed at the factory, and disruption of this seal could
void the authorization to operate the equipment.
Sincerely,
Xinhua Gan
RF Design Engineer
440-528-7200
xgan@aclara.com
Loading...