ACI-Automation Components A/Plastic Button Sensor Instruction Sheet

Installation and Operation Instructions

A/Plastic Button Sensor

READ THESE INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION

All ACI thermistors and RTD temperature sensors are both non-polarity and non-position sensitive. All thermistor and
RTD type sensors are included with (2) 22 AWG stranded etched Teflon wires for making all of the proper connections.

 TROUBLESHOOTING
Sensor reads 0 ohms or very low Sensor or wires are shorted together
Sensor reads infinity or very high Sensor or wires have been damage and are open
Erratic readings Bad wire connections - Condensation or Moisture problem

 PART DESCRIPTIONS

Plastic Button

 MOUNTING INSTRUCTIONS
Mounting in sheetrock is done through a ½” hole using regular hand tools as shown in Figure 1. Mounting into marble or
rock can be done directly in a ¼” hole without the threaded insert. If you have any further questions or comments regarding
the Button sensor, please call ACI for technical assistance.

Threaded Insert

FIGURE 1

WALL

 WEEE Directive

At the end of their useful life the packaging and product
should be disposed of via a suitable recycle center. Do
not dispose of with household waste. Do not burn.