Page 1
Pre-Install AMD® AHCI Driver for
Windows XP® Operating System
Pre-Installation Using the F6 Method
Notes:
Before you start to install Microsoft® Windows XP® operating system, you will need an
optical drive, a USB floppy disk drive, a blank 1.44MB floppy diskette, and Microsoft®
Windows XP® Professional/Home Edition Setup Disc (bootable).
1. Extract AHCI F6 driver files to a blank 1.44MB floppy diskette. Make sure the following files are
contained in the root directory:
2. Connect the USB floppy drive and then boot up from the Microsoft® Windows XP®
Professional/Home Edition Setup Disc to install operating system.
Page 1 of 4
Page 2
3. At the beginning of the operating system installation, press [F6] to install a third party SCSI or
RAID driver.
4. When prompted, select 'S' to Specify Additional Device.
Page 2 of 4
Page 3
5. Insert the floppy diskette you created in step 1.
6. At this point you should be presented with a selection for one of the following controllers listed
depending on your hardware version and configuration for AHCI Controllers:
- Select [AMD AHCI Compatible RAID Controller-x86 platform] for Windows XP 32-bit Edition
- Select [AMD AHCI Compatible RAID Controller-x64 platform] for Windows XP 64-bit Edition
Page 3 of 4
Page 4
7. Highlight the selection that is appropriate for the hardware in your system and press Enter.
8. Press Enter again to continue.
- Load [AMD AHCI Compatible RAID Controller-x86 platform] driver
- Load [AMD AHCI Compatible RAID Controller-x64 platform] driver
Leave the floppy diskette in the system until the next reboot as the software will
need to be copied from the floppy diskette again when setup is copying files.
Page 4 of 4
Loading...