The information in this guide is subject to change without notice.
Acer Incorporated makes no representations or warranties, either expressed
or implied, with respect to the contents hereof and specifically disclaims any
warranties of merchantability or fitness for any particular purpose. Any Acer
Incorporated software described in this manual is sold or licensed "as is".
Should the programs prove defective following their purchase, the buyer (and
not Acer Incorporated, its distributor, or its dealer) assumes the entire cost of
all necessary servicing, repair, and any incidental or consequential damages
resulting from any defect in the software.
Acer is a registered trademark of Acer Corporation.
Intel is a registered trademark of Intel Corporation.
Pentium 4 and Celeron are trademarks of Intel Corporation.
Other brand and product names are trademarks and/or registered trademarks
of their respective holders.
III
Conventions
The following conventions are used in this manual:
SCREEN
Denotes actual messages that appear on screen.
MESSAGES
NOTE Gives bits and pieces of additional information
related to the current topic.
WARNING Alerts you to any damage that might result from
doing or not doing specific actions.
CAUTION Gives precautionary measures to avoid possible
hardware or software problems.
IMPORTANT Remind you to do specific actions relevant to the
accomplishment of procedures.
IV
Preface
Before using this information and the product it supports, please read the
following general information.
1. This Service Guide provides you with all technical information relating to
the BASIC CONFIGURATION decided for Acer's "global" product offering.
To better fit local market requirements and enhance product
competitiveness, your regional office MAY have decided to extend the
functionality of a machine (e.g. add-on card, modem, or extra memory
capability). These LOCALIZED FEATURES will NOT be covered in this
generic service guide. In such cases, please contact your regional offices or
the responsible personnel/channel to provide you with further technical
details.
2. Please note WHEN ORDERING FRU PARTS, that you should check the
most up-to-date information available on your regional web or channel. If,
for whatever reason, a part number change is made, it will not be noted in
the printed Service Guide. For ACER-AUTHORIZED SERVICE
PROVIDERS, your Acer office may have a DIFFERENT part number code
to those given in the FRU list of this printed Service Guide. You MUST use
the list provided by your regional Acer office to order FRU parts for repair
and service of customer machines.
V
Chapter 1 System Specifications 1
Features……………………………………………………………………………………………... 1
Main board Placement…………………………………………………….……..……………..6
Block Diagram…………………………………………………………..………………...………..8
VeritonM670G/M670 Front Panel………………..…….……………………….…..……....9
VeritonM670G/M670 Rear Panel…………………………………………..…….………10
VeritonS670G/S670 Front Panel………………..…………………………..…..……...11
VeritonS670G/S670Rear Panel…………………………..………..…………………12
Hardware Specifications and Configurations………………….…….……..13
Power Management Function (ACPI support function)…………………………..…...18
Chapter 2 System Utilities 19
Entering Setup…………………………………………………………………………..20
Product Information………………………………………………………..21
Standard CMOS Setup………………………….…….……………………………………22
Advanced BIOS Features………………………………………..……………………23
Advanced Chipset Setup………………………...…………………………………………..25
Integrated Peripherals…………………………...…………………………………………..26
Power Management…………………………………………………………28
PC Health Status……………………………………………………………...29
Frequency/Voltage Control……………..………………………….…….30
BIOS Security Features…………..…………………………….…….31
Load Default Settings………………………………………………..……. 32
Save & Exit Setup………………………………………………….…………33
Exit Without Saving………………………………………………….……..34
Chapter 3 Machine Disassembly and Replacement 35
General Information………………………………………………………. 36
Disassembly Procedure……………………………………………………37
VeritonM670G/M670/S670G/S670 Disassembly Procedure……………38
Chapter 4 Troubleshooting 52
Chapter 5 Jumper and Connector Information 53
Jumper Setting…………………………………………………..………………..53
Chapter 6 FRU (Field Replaceable Unit) List 59
Exploded Diagram………………………………………………………….60
Chapter 1
System Specifications
Features
Operating System
Microsoft Windows Vista (Home Basic, Home Premium, Business)
Support single channel 64 bit mode with maximum memory size up to 8GB
Support un-buffered DIMM (Intel Q35/Q33)
DIMM Slot: 4
Memory Max: 512MB to 8GB DDR2 memory technologies
PCI
PCI Express Slot Type: x16
PCI Express Slot Type: x1
PCI Slot Type: PCI 2.3 5V slots
PCI Express x16 Slot Quantity: 1
PCI Express x1 Slot Quantity: 1
1
PCI Slot Quantity: 2
FDD
Slot Quantity: 1
Design Criteria:
Should support 1.44MB/3 mode 3.5” Devices
SATA
Slot Type: SATA slot
Slot Quantity: 6
Storage Type support:
1 2*5 pin Intel FPIO spec. Microphone In/ Headphone Out pin connectors
1 serial port 2*5 pin connector (2nd serial port)
1 2*4 pin internal speaker header
1 4 pin CPU Fan connector
1 3 pin System FAN connector with linear circuit
1 2pin Intrusion Alarm connector
1 24pin + 4pin ATX interface PS3/PS2 SPS connector
1 2*7 pin front panel IO header
1 Jumper for clear CMOS
1 on board buzzer
1 2pin OBR header
2 reserved 2pin GPIO connector
Color management for on board connecter (pls refer to Acer spec)
4
1 x LTP 2*13pin header
1 2x5pin Front Audio header
1 3pin ME enable/disable connector (with 1 jumper)
Power Supply
Power Supply Mounting Features
Chassis accepts ATX-style power supply
Chasses accepts PS2, PS3 style power supply
Features for internal mounting tab
Location of 4 external mounting holes
Power Supply Electrical Design Feature
300W/250W in stable mode (Acer Assign System Power Unit)
Design for Intel Broadwater/ICH8 series chipset compatible system
Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V
(attention to 12V output capability)
Demand for both PFC/Non-PFC solutions (two different quotations are
needed)
Minimum 2 Serial ATA power connector solution should be included (by
default)
Minimum 3 big 4-pin power connector included
Minimum 1 small 4-pin power connector included
PFC version will not provide switch selector for 115/230V AC input but it
should be universal for Europe and China
Non-PFC version should provide switch selector for 115/230V AC input
and universal for worldwide
PS2 style
5
Main board Placement
6
7
Block Diagram
8
VeritonM670G/ M670 Front Panel
Label Description
1 USB ports
2 ACER Logo
3 FDD cover
4 LEDs
5 MIC connector
6 Audio connector
7 Optical drive
8 Card reader
9 Power Button
4 DVI port 11 LAN connector
5 USB 2.0 ports 12 Lock Handle
6 Audio connector
7 Fan aperture
10
VeritonS670G/S670 Front Panel
Label Description
1 Power Button
2 Optical drive
3 FDD cover
4 ACER Logo
5 Audio connector
6 USB ports
7 Card reader
11
VeritonS670G/S670 Rear Panel
Label
1 Power card socket 6 Audio connector
2 PS/2 keyboard connector 7 Com connector
3 PS/2 mouse connector 8 Monitor connector
4 DVI port 9 LAN connector
5 USB 2.0 ports 10
Description
Label Description
12
Hardware Specifications and Configurations
Processor
Item Specification
Type Processor Type: Intel Conroe /Kensfield /Wolfdale
/Yorkfield processor FSB 1333/1066/800 MHz CPUs
Socket LGA 775 pin
FSB 800/1066/1333 MHz CPUs
Minimum operating speed 0 MHz (If Stop CPU Clock in Sleep State in BIOS
Setup is set to Enabled.)
BIOS
Item Specification
BIOS code programmer Phoenix Award or AMI Kernel with Acer skin
BIOS version V6.0
BIOS ROM type SPI Flash
BIOS ROM size 32Mb
Support protocol SMBIOS (DMI) 2.4/DMI 2.0 (log file)
Device Boot Support
Support to LS-120 drive YES
Support to BIOS boot block
feature
- 1st priority: SATA HDD
- 2nd priority: CD-ROM
- 3rd priority: FDD
- 4th priority: LAN
- 5th priority: USB device
YES
BIOS Hotkey List
Hotkey Function Description
Del Enter BIOS Setup Utility Press while the system is booting to enter
BIOS Setup Utility.
13
Main Board Major Chips
Item Specification
North Bridge Intel Q35 and Q33
South Bridge
APG controller Intel Q45
Super I/O controller ITE 8718
Audio controller HD audio codec ALC888S HD codec 7.1 (co-lay with LC888)
LAN controller Intel Boazman 82567LM PCI-E Giga LAN
HDD controller Intel ICH10DO
Keyboard controller Super I/O ITE 8720
Intel ICH9DO/ICH9
Memory Combinations
Slot Memory Total Memory
Slot 1 512MB, 1GB, 2GB 512MB~2GB
Slot 2 512MB, 1GB, 2GB 512MB~2GB
Maximum System Memory Supported 512MB~8GB
System Memory
Item Specification
Memory slot number 4 slot
Support Memory size per socket 512MB/1GB/2GB
Support memory type DDR3
Support memory interface DDR3 800/1066MHz
Support memory voltage 1.8V
Support memory module package 240-pin DDR3
Support to parity check feature Yes
Support to error correction code (ECC) feature No
Memory module combinations You can install memory modules in
any combination as long as they
match the above specifications.
14
Audio Interface
Item Specification
Audio controller Intel ICH9DO/ICH9
Audio controller type ALC888S
Audio channel codec 7.1
Audio function control Enable/disable by BIOS Setup
Mono or stereo Stereo
Compatibility Sound Blaster Pro/16 compatible Mixed
digital and analog high performance
chip Enhanced stereo full duplex
operation High performance audio
accelerator and AC’97 support Full
native DOS games compatibility Virtual
FM enhances audio experience through
real-time FM-to-Wavetable
conversionMPU-401 (UART mode)
interface for Wavetable synthesizers and
MIDI devices Integrated dual game port
Meets AC’97and WHQL specifications
Music synthesizer Yes, internal FM synthesizer
Sampling rate 48 KHz (max.)
MPU-401 UART support Yes
Microphone jack Supported
Headphone jack Supported
SATA Interface
Item Specification
SATA controller Intel ICH10DO
SATA controller resident bus PCI bus
Number of SATA channel SATA X 6
Support bootable CD-ROM YES
15
Loading...
+ 46 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.