Acer CB342CKsmiiphzx Quick guide

LCD monitor CB2

series-CB342CK

USER GUIDE

Acer LCD Monitor Quick Start Guide (QSG)

Important safety instructions

Please read the following instructions carefully.

1. To clean the LCD monitor screen:

• Turn off the LCD monitor and unplug the power cord.

• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.

2. Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely
damage it.

3. Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.

4. Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform
servicing of any nature.

5. Store the LCD monitor in a room with a temperature of -20° to 60°C (-4° to140°F). Storing the LCD monitor
outside this range may result in permanent damage.

6. Immediately unplug your monitor and call an authorized technician if any of the following circumstances
occur:

• Monitor-to-PC signal cable is frayed or damaged.

• Liquid spills onto the LCD monitor or the monitor is exposed to rain.

• The LCD monitor or case is damaged.

English

Package contents

LCD monitor Power cord

HDMI cable

(optional)

DP cable

(optional)

USB cable
(optional)

Quick start guide

LCD monitor CB2 series-CB342CK

USER GUIDE

Attaching the monitor to the stand

1. Remove the monitor bracket and base from the packaging and place it on a stable and level workspace.

2. Remove the monitor from the packaging, by aligning the front-end of the bracket with the corresponding

screw holes on the back of the display,Replace the four screws that secure the monitor to the bracket .
Tighten the screws firmly.

3. Attach the footstand to the base.Turn clockwise to lock. Ensure that the base in locked onto the stand.

4. Secure the base to the stand by turning the screw using the intergrated tab or a suitable coin.

Connecting your monitor to a computer

1. Turn off your computer and unplug your computer's power
cord.

2. Connect the signal cable to the DP (optional) and/or
HDMI (optional) input socket of the monitor, and the
DP (optional) and/or HDMI (optional) output socket of
the graphics card on the computer. Then tighten the
thumbscrews on the signal cable connector.

3. USB Upstream /USB Downstream (Battery Charger) /USB
Downstream

Connect one end of the USB cable to the USB terminal of

the monitor, and connect the other end of the USB cable
to an appropriate USB port on your device.

The USB downstream port does not provide power

Note:

while the monitor switch is off.

USB Downstream
(Battery Charger)

USB Downstream

USB Downstream
(Battery Charger)

USB Downstream

PC