Ace Hardware Door User Manual

Hardwired
®
Electronic
Chime
© 2005 598-1224-00
-2-
598-1224-00
IMPORTANT: Proper installation requires a diode on the front door push button. See Diode Installation Instructions (page 5) after completing steps 1 through 10 below.
Note: Electrical work must be in accordance with national and local electrical codes. If in doubt, consult a qualified electrician.
1. Verify transformer power rating. Power must be supplied from a 16 Volt AC, 10 Watt or a 16 Volt AC, 15 Watt transformer.
2. Remove cover from existing chime.
3. Label all wires before disconnecting. Using masking tape, mark each wire according to existing chime terminal markings.
• “F” – Front Push Button Wire
• “T” – Transformer Wire
• “R” – Rear Push Button Wire*
4. Disconnect all wires from existing chime.
5. Remove existing chime base from wall.
6. Determine proper chime base orientation. The chime cover style will determine orientation.
7. Determine cover mounting type. For hanging type covers, cover pin should be exposed (see Figures 1 and 3).
Cover Pin (Used for Hanging Type Covers)
Volume Control
Front Door Tune Selection Switch (On Select Models) “A” - Westminster “B” - Whittington
Transformer and Push Button Wire Connections
Figure 1 - Electronic Chime Identification
Base Orientation Marking
Mounting Hole (x4)
Wire Entrance Hole
(TR-0070-BX Base Shown)
Continued
Illustrations may vary from actual chime unit.
8. Route wires through wire entrance hole in new chime base.
FRONT
VOLUME
FRONT TUNE
A
B
TRANS
REAR
F
R
T
9. Mount chime base to wall using screws and anchors provided. (Drill 7/32" diameter pilot hole for wall anchors.)
10. Connect wire “F” to screw terminal marked “FRONT”. Connect wire “T” to screw terminal marked “TRANS”. Connect wire “R” to screw terminal marked “REAR”* (See Figure 2).
11. Install chime cover (see page 4).
12. Connect diode to front push button (see page 5).
*Note: Some installations may not include rear door push button.
Existing Chime Wires
Wall
Replacement Chime Base
Rear Door Push Button (if Applicable)
Figure 2 - Electronic Chime Wiring
(TR-0070-BX Base Shown)
-3-
598-1224-00
Loading...
+ 5 hidden pages