ACE Controls VC Precision Hydraulic Feed Controllers User Manual

Installation Instructions

VC Precision Hydraulic Feed Controllers

Mounting block can
be installed anywhere
on the body.

Optional Thread
Mount on flat surfaces
using ACE mounting
block. May also be
installed in suitable
machined hole. Do

not use set screws.

Mounting Block

M25 x 1.5

23435 Industrial Park Drive
Farmington Hills, Michigan 48335
tel: [phone]
fax: [phone]

www.acecontrols.com

Piston rod must
butt directly against
object to be controlled.
It should not contact
object at an angle
exceeding 1 .

0

0

2 max

1. Do not exceed 1,500 in/min (38 m/min) velocity without consulting factory.

2. VC may be mounted in any position.

3. To prevent internal damage, do not twist (rotate) VC plunger.

4. Operating temperature range: 32 to 140 F (0 to 60 C)

0000

5. Protect unit from weld flash, petroleum based fluids and external damage.

6. Contact factory when the VC must be exposed to an oil environment.

7. Adjustment instructions:
a) To increase feed rate, rotate adjustment knob counterclockwise.
b) To decrease feed rate, rotate adjustment knob clockwise.

0

1 max

ACE Controls Inc.

World leader in deceleration technology

ISO 9001:2000 Certified

ACE Form 15, VC

04/01/2004