Accusplit 1620 User Manual

ACCUSPLIT®

ACCUSPLIT EAGLE 1620

TW15MG

STEP

RESET

MY

10K-A-DAY

™

425 I

EAGLE

ACTIVITY PEDOMETER

OPERATING INSTRUCTIONS

Congratulations on taking the first step to wellness with your purchase

of an ACCUSPLIT pedometer. It’s easy to set up your new pedometer.

Just follow the steps below, and start walking!

™

1620

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should
fit snugly and level, above one knee.
Note: The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
The cover must be closed for the pedometer to work. To avoid
losing or dropping your pedometer, use the included leash and
clip to fasten the pedometer securely to your clothing.

Attaching the Leash: Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp the
waistband of your clothing with the attached metal clip. You can
also use a safety pin to fasten the leash to your clothing, loop
the leash through your belt or belt loop, or use a badge holder.

First, loop the
pedometer clip

Next, loop the metal clip,
then clasp clothing

Or, loop a belt or
belt loop

badge holder, then

(Badge holder not included)

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it will
automatically begin to record your steps.

Or, loop a

put into pocket

DISPLAY MODES

• STEPS: Counts steps taken since last RESET.
Reset daily to count each day’s steps.

Yellow:

RESET

AUTO MOVEMENT SENSOR

1. To filter out random movements, the unit remains in standby mode until
5 continuous steps are registered. Only then are the 5 steps calculated in,
and an Active indicator “

2. When regular walk/run movement stops, after 2 seconds the timer pauses
and the unit switches to standby status (Active indicator “▲” disappears)

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset: Press and hold yellow
RESET button for at least two seconds to reset to zero.

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to replace the battery.
Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To
replace:

1. Insert a coin into the slot on the bottom of the case, and twist counter­ clockwise to loosen the case front. Lift case front away.

2. Using a pen or other thin object, push battery sideways out of its holder.
Replace it with a new battery. The battery’s positive (+) terminal should
be FACE UP while you put it into the pedometer.

3. Align case front over the pedometer and press gently to
snap cover back into place, starting with top.

▲” appears on the upper left of display.

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

See label inside the lid of the pedometer.

800-965-2008 • 925-226-0888 • FAX [phone] • www.ACCUSPLIT.com • [e-mail]

REGISTER NOW Please return

your AE1620 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.

Email (preferred)

User

E Rig! W Mr! Lv W!

 ACCUSPLIT Lftl

ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA

970-066