Accusplit 1520M2 User Manual

ACCUSPLIT®
ACCUSPLIT EAGLE
AccuSTEP 10000.org
TW15G
1520M2
STEP
D T
RESET (2S) MODE
99
EAGLE
MEMORY PEDOMETER
OPERATING INSTRUCTIONS
Congratulations on taking the rst step to wellness with your purchase of an
ACCUSPLIT pedometer. It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
1520M2
WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should t
snugly and level, above one knee. Note: The pedometer should be as vertical as possible. Walkers
with larger stomachs may nd it helpful to wear the pedometer
farther back on the body, toward one hip. The cover must be closed for the pedometer to work. To avoid losing or dropping your pedometer, use the included leash and clip to fasten the pedometer securely to your clothing.
Attaching the Leash: Attach the pedometer to the leash by looping the leash around the pedometer belt clip. Next, loop the leash through the enclosed plastic clip, then clasp the waistband of your clothing with the clip. You can also use a safety pin to fasten the leash to your clothing, loop the leash through your belt or belt loop or use a badge holder.
First, loop the pedometer clip
Next, loop the metal clip, then clasp clothing
Or, loop a belt or belt loop
badge holder, then
(Badge holder not included)
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will automatically begin to record your steps. Repeatedly press the yellow MODE button to cycle through the pedometer modes: DAILY STEPSTOTAL STEPSDAILY STEPS
REGISTER NOW Please return
your 1520M2 Registration to the Repair Center address in the warranty, and we will let you know about future products.
Email (preferred)
User
Or, loop a
put into pocket
DISPLAY MODES
• “D”– “Day’s STEPs” Counts steps taken since last RESET. Reset daily to count each day’s steps.
• “T”–”Total STEPS” Keeps track of all steps taken, even after Day’s STEPs are reset.
“D”=Day “T”=Total
MODE and RESET button
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: While displaying Day’s STEPs, press and hold MODE button for at least three seconds to reset to zero. When displaying Total STEPs, press MODE button for three seconds to reset Total and
Day’s STEPs to zero.
AUTO MOVEMENT SENSOR
1. To lter out random movements, the unit remains in standby mode until 5 continuous steps are registered. Only then are the 5 steps calculated in, and an Active indicator “” appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the timer pauses and the unit switches to standby status (Active indicator “” disappears).
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace the battery. Your pedometer uses one Type LR44 1.5 volt alkaline battery. To replace:
1. Insert a coin into the slot on the bottom of the case, and twist counterclockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out of its holder. Replace it with a new battery. The battery’s positive (+) terminal should be FACE UP while you put it into the pedometer.
3. Align case front over the pedometer and press gently to snap cover back into place, starting with top.
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • support@ACCUSPLIT.com
See label inside the lid of the pedometer.
ACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131
E Rig! W Mr! Lv W!
 ACCUSPLIT Lftl
970-044
Loading...