Accton Wireless Broand US211 User Manual
U
SER
G
UIDE
Mobile WiMAX USB Adapter
US211
U
SER
G
UIDE
US211
IEEE 802.16e-2005 Mobile WiMAX USB Adapter,
with 2.3, 2.5, and 3.5 GHz Frequency Band Models
US211
E072009-AP-R01
149100000031W
COMPLIANCES
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
◆ Reorient or relocate the receiving antenna
◆ Increase the separation between the equipment and receiver
◆ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
◆ Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
IMPORTANT NOTE:
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. To maintain compliance
with FCC RF exposure compliance requirements, please follow operation
instruction as documented in this manual.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. The availability of some specific channels
and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
– 3 –
C
OMPLIANCES
Due to the essential high output power nature of WiMAX devices, use of
this device with other transmitters at the same time may exceed the FCC
RF exposure limit and such usage must be prohibited (unless such cotransmission has been approved by FCC in the future).
SAR (SPECIFIC ABSORPTION RATE) COMPLIANCES STATEMENT
SAR compliance has been established in typical laptop computer (s) with a
USB slot, and the product can be used in typical laptop computers with
USB slots. Other applications, such as handheld PCs or similar devices have
not been verified and may not be in compliance with related RF exposure
rules and such use shall be prohibited.
EC CONFORMANCE DECLARATION
Marking by the above symbol indicates compliance with the Essential
Requirements of the R&TTE Directive of the European Union (1999/5/EC).
This device is intended for use in the following European Community
countries.
NCC 警語
『減少電磁波影響請妥適使用』
– 4 –
ABOUT THIS GUIDE
PURPOSE This guide details the hardware features of the US211 WiMAX USB Adapter,
including its physical and performance-related characteristics, and how to
install the device and use its configuration software.
AUDIENCE This guide is for PC users with a working knowledge of computers. You
should be familiar with Windows operating system concepts.
CONVENTIONS The following conventions are used throughout this guide to show
information:
N
OTE
:
Emphasizes important information or calls your attention to related
features or instructions.
C
AUTION
damage the system or equipment.
W
ARNING
:
Alerts you to a potential hazard that could cause loss of data, or
:
Alerts you to a potential hazard that could cause personal injury.
RELATED PUBLICATIONS The following publication gives basic information on how to install and use
the WiMAX USB Adapter.
Quick Installation Guide
Also, as part of the card’s configuration software, there is online help that
describes all management features.
REVISION HISTORY This section summarizes the changes in each revision of this guide.
JULY 2009 REVISION
This is the first revision of this guide. This guide is valid for software
version 2.0.0.0.
– 5 –
CONTENTS
COMPLIANCES 3
A
BOUT THIS GUIDE 5
ONTENTS 6
C
1I
NTRODUCTION 8
Features 8
System Requirements 9
Package Checklist 9
USB Connector 9
LED Indicators 10
2INSTALLATION 11
3C
ONFIGURATION 15
Accessing the WCM Utility 15
Display Options 16
View Menu Options 17
Connection Management 17
Lost WiMAX Connection 18
Selecting Profiles 19
Editing a Profile 20
Card Settings 22
Network Information 25
WiMAX Connection Statistics 26
Tool Menu 27
Disable Menu Bar 27
Turning Power On/Off 27
Safely Remove Hardware 27
Lock WiMAX Network Adapter Now 28
Sounds for Events 28
Software Upgrade 29
– 6 –
C
ONTENTS
4ADMINISTRATOR MODE 30
Accessing Administrator Mode 30
Setting Profiles 31
Creating a New Profile 32
Advanced Configuration 37
ATROUBLESHOOTING 39
Diagnosing LED Indicators 39
Network Connection Problems 39
Uninstalling the WCM Software 40
BSPECIFICATIONS 42
G
LOSSARY 45
I
NDEX 49
– 7 –
1 INTRODUCTION
The WiMAX USB Adapter is a network adapter that enables a notebook PC
to connect to a service provider’s 2.3 GHz, 2.5 GHz or 3.5 GHz mobile
WiMAX network.
The USB adapter plugs directly into a PC’s compatible USB port and
includes its own driver and configuration software for Windows XP and
Windows Vista.
Figure 1: WiMAX USB Adapter
FEATURES
◆ Mobile WiMAX IEEE 802.16e-2005 Wave 2 compliant
◆ Three models for 2.3 GHz, 2.5 GHz or 3.5 GHz mobile WiMAX networks
◆ Full Non-Line-of-Sight (NLOS) operation
◆ Two LED indicators for power and link status
◆ Easy installation with a user-friendly interface for configuration.
◆ Driver support for Windows XP with Service Pack 2 (SP2) and Windows
Vista
– 8 –
SYSTEM REQUIREMENTS
Before you install the WiMAX USB Adapter, check your system meets the
following requirements:
◆ A notebook or desktop computer with a USB port
◆ Microsoft Windows XP or Windows Vista
◆ Microsoft .NET Framework Version 2.0 (or higher) installed on the host
◆ A 1 GHz Pentium CPU or higher with a minimum of 256 MB of RAM
PACKAGE CHECKLIST
computer
C
HAPTER
1
| Introduction
System Requirements
The WiMAX USB Adapter package includes these items:
◆ WiMAX USB Adapter (US211)
◆ Quick Installation Guide
Inform your dealer if there are any incorrect, missing or damaged items. If
possible, retain the carton, including the original packing materials. Use
them to repack the product in case there is a need to return it.
Hardware Description
The US211 WiMAX USB Adapter enables notebook PC users to connect to a
WiMAX Internet access service provider.
USB CONNECTOR The USB adapter can be installed in any notebook PC with a USB port. The
notebook PC must be running Windows XP with Service Pack 2 or Windows
Vista.
– 9 –
Loading...