Accton Wireless Broand PC200 User Manual

PC200
2.3/2.5/3.5 GHz Mobile WiMAX CardBus Card
User Guide
User Guide
PC200
IEEE 802.16e-2005 Mobile WiMAX CardBus Card, with 2.3, 2.5, and 3.5 GHz Frequency Band Models
Compliances
"Due to the essential high output power natural of WiMAX device, use of this
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
FCC ID: V8YFW638PC25000W is for 2.5G only.
IMPORTANT NOTE: FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.
SAR (Specific Absorption Rate) Compliance Statement
SAR compliance has been established in typical laptop computer(s) with a CardBus slot, and the product can be used in typical laptop computers with CardBus slots. Other applications, such as handheld PCs or similar devices have not been verified and may not be in compliance with related RF exposure rules and such use shall be prohibited.
i
EC Conformance Declaration
Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). This equipment meets the following conformance standards:
• EN 60950-1 (IEC 60950-1) - Product Safety
• EN 301 489-1, EN 301 489-4 - EMC requirements for radio equipment
• EN 50385 - Country specific SAR requirements
This device is intended for use in all European Community countries:
ii
About This Guide
Purpose
This guide details the hardware features of the PC200 WiMAX CardBus Card, including its physical and performance-related characteristics, and how to install the device and use its configuration software.
Audience
This guide is for PC users with a working knowledge of computers. You should be familiar with Windows operating system concepts.
Conventions
The following conventions are used throughout this guide to show information:
Note: Emphasizes important information or calls your attention to related features or
instructions.
Caution: Alerts you to a potential hazard that could cause loss of data, or damage the
system or equipment.
Warning: Alerts you to a potential hazard that could cause personal injury.
Related Publications
The following publication gives basic information on how to install and use the WiMAX CardBus Card.
Quick Installation Guide
Also, as part of the card’s configuration software, there is online help that describes all management features.
Revision History
This section summarizes the changes in each revision of this guide.
July 2008 Revision
This is the first revision of this guide. This guide is valid for software version 1.0.3.0.
iii
iv
Contents
Chapter 1: Introduction 1-1
Features 1-1 System Requirements 1-2 Package Checklist 1-2 Hardware Description 1-2
Antennas 1-2 CardBus Connector 1-2 LED Indicators 1-3
Chapter 2: Installation 2-1
Chapter 3: Configuration 3-1
Accessing the WCM Utility 3-1 Display Options 3-2
View Menu Options 3-3
Connection Management 3-4
Lost WiMAX Connection 3-5
Selecting Profiles 3-6
Editing a Profile 3-7 Card Settings 3-9 Network Information 3-13 WiMAX Connection Statistics 3-14 Tool Menu 3-16
Disable Menu Bar 3-16
Turning Power On/Off 3-16
Safely Remove Hardware 3-17
Lock PC Card Now 3-17
Sounds for Events 3-17 Software Upgrade 3-19
Chapter 4: Administrator Mode 4-1
Accessing Administrator Mode 4-1 Setting Profiles 4-3
Adding a New Profile 4-4 Advanced Configuration 4-8
v
Contents
Appendix A: Troubleshooting A-1
Diagnosing LED Indicators A-1 Network Connection Problems A-1 Uninstalling the WCM Software A-2
Appendix B: Specifications B-1
Glossary
Index
vi

Chapter 1: Introduction

The WiMAX CardBus Card is a network adapter that enables a notebook PC to connect to a service provider’s 2.3 GHz, 2.5 GHz or 3.5 GHz mobile WiMAX network.
The CardBus card plugs directly into a PC’s compatible card slot and includes its own driver and configuration software for Windows XP and Windows Vista. The card includes two folding antennas that can be adjusted for best signal reception.
Antennas
LED Indicators
CardBus Connector
Figure 1-1. WiMAX CardBus Card

Features

• Three models for 2.3 GHz, 2.5 GHz or 3.5 GHz mobile WiMAX networks.
• Two fold-out antennas for optimal signal reception.
• Two LED indicators for power and link status.
• Easy installation with a user-friendly interface for configuration.
• Driver support for Windows XP with Service Pack 2 (SP2) and Windows Vista.
• Strong network security support.
1-1
Loading...
+ 24 hidden pages