Accell UltraAV HDMI 1x2 Splitter User Manual

UltraAV® HDMI 1x2 Audio/Video Splitter

READ ME FIRST – SETUP INSTRUCTIONS

Congratulations on your purchase of the UltraAV HDMI 1-2 Audio/Video Splitter. This HDMI splitter is designed
to provide exceptional performance and value. It allows access to 2 HDMI display devices from a single HDMI
video source. For a DVI device, use an optional HDMI to DVI adapter or HDMI to DVI cable.

Features:

• Connectors: 1 input/2 output, HDMI Type A female

• Supported resolutions: Up to 1080p/120Hz

• Total data rate: 6.75Gbps (225MHz)

• Signal repeater: Supports up to 30’ cable length from

• Splitter to Display. Note: Amplified HDMI cables can reach extended lengths.

• Power: 100-240VAX, 50/60Hz

• Dimensions: 2.75"W x 2.75"L x 1.2H

• Weight: 2 ounces

Mounting the HDMI Splitter:

As an alternative to placing the 1-2 Splitter flat on its foot pads, the HDMI splitter features 2 wall mounting slots
located on the back of the switch. The switch can easily be mounted to a wall or panel.

How to Connect the HDMI Splitter:
Step 1: Plug the power adapter into the “Power Jack” on the splitter. Plug the adapter into a power outlet.
Step 2: Connect your HDMI cable from the video source into the HDMI splitter input labeled “In”.
Step 3: Connect your HDMI cables from each of the two displays into the splitter outputs labeled “Out”.

Channel Indicator:

A channel indicator LED becomes illuminated when the video display, which is connected to its corresponding
HDMI port, is properly connected to it by an HDMI cable and is powered on. The LED will also illuminate when
the display is in power saving mode.

Troubleshooting:

-If the HDMI splitter fails to operate,

1. Ensure the HDMI source and the displays (or projector) are powered on.

2. Check both ends of all of the HDMI cables to ensure that they are fully inserted into each device.

3. Inspect the power adapter to ensure it is plugged into the power jack of the splitter. Ensure the power

adapter is plugged into the power outlet and the power outlet is supplying power.

Assistance: If you have questions regarding the Accell HDMI switch, please check out our Web site at:
www.accellcables.com. Technical Support can be reached at 510-438-9288 (M-F 9am-5pm PST).

Includes:

• HDMI 1-2 splitter

• Power adapter

• Setup instructions

ACCELL 1-YEAR LIMITED MANUFACTURERS WARRANTY

for one year from date of purchase to be free of defects in material and workmanship. In the event of such defects, the Accell product will
be repaired without charge or, at our option, replaced with a new one if delivered to Accell Corporation prepaid, together with a copy of the
dated sales receipt. This warranty excludes defects due to normal wear, abuse, shipping damage, or failure to use the cable in accordance
with the instructions. ACCELL CORPORATION SHALL NOT BE LIABLE FOR DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE OF THE
CABLE OR OTHER ACCELL PRODUCT, LOSS OF TIME, INTERRUPTED OPERATION OR COMMERCIAL LOSS, OR ANY OTHER DAMAGES,
WHETHER INCIDENTAL, CONSEQUENTIAL OR OTHERWISE. This warranty gives you specific legal rights, and you may have other rights that
vary from state to state vary from state to state.

Limitation Of Liability.

PARTNERS, OFFICERS, DIRECTORS, EMPLOYEES, SHAREHOLDERS, REPRESENTATIVES OR AGENTS (COLLECTIVELY, "ACCELL") BE LIABLE
FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR INDIRECT DAMAGES (INCLUDING BUT NOT LIMITED TO, LOSS OF
DATA, USE OR PROFITS), HOWEVER CAUSED, WHETHER FOR BREACH OF CONTRACT, NEGLIGENCE, OR OTHERWISE, AND WHETHER OR
NOT ACCELL HAS BEEN ADVISED OF THE POSSIBILITY OF ANY SUCH DAMAGES. YOU AGREE THAT ACCELL'S MAXIMUM LIABILITY ARISING
FROM ANY PRODUCT SOLD BY ACCELL SHALL NOT EXCEED THE PRICE OF SUCH PRODUCT. SOME JURISDICTIONS DO NOT ALLOW THE
LIMITATION OF EXCLUSION OF LIABILITY FOR CERTAIN DAMAGES, SO THE ABOVE MAY NOT APPLY TO YOU TO THE EXTENT SUCH
JURISDICTION'S LAW IS APPLICABLE TO THIS AGREEMENT.

Warranty Returns Procedure.

or call 510-438-9288 to obtain a Return Authorization (RMA) number. RMA numbers are valid for 30 days from the date of issuance. We are
unable to accept returns without an RMA number. Returns without an Accell issued RMA number clearly printed on the outside of the
package will be returned unopened. All returns must be shipped prepaid at the expense of the shipper. All returns must include a copy of
the dated sales receipt. Due to ongoing improvements, Accell reserves the right to make changes to hardware, packaging and any
accompanying documentation without prior written notice. The information above is believed to be accurate, however Accell assumes no
responsibility for any inaccuracies and liability for direct, indirect, special, incidental, or consequential damages as a result. UltraAV is a
trademark of Accell Corporation.

Due to ongoing improvements, Accell reserves the right to make changes to hardware, packaging and any accompanying documentation

without prior written notice. The information above is believed to be accurate, however Accell assumes no responsibility for any inaccuracies

and liability for direct, indirect, special, incidental, or consequential damages as a result.

UltraAV is a trademark of Accell Corporation.

IN NO EVENT SHALL ACCELL CORPORATION, ITS SUBSIDIARIES OR AFFILIATES, OR THEIR RESPECTIVE

To return an item under warranty, contact Customer Support by E-mail at [e-mail]

 2011 Accell Corporation, All Rights Reserved

The Accell 1x2 Splitter, which is purchased in the U.S.A., is warranted