ABtUS AV890-610 User Manual

INSTALLATION

Step-6 —Cables management:
A. from top of casing by breaking the tag on the cover.
B. for concealed cable from wall.
C. remoce End Cap, slide Silde Covers out from Arm, run cables and slide covers back to place.

Slide covers

(A)

(B) (C)

End Cover

slide

Short Throw

Projector Wall

Mount

Slide

7a

B

screen

** For details and updated Command and Program Software, please visit and download from www.abtussingapore.com

*Specifi cations are subject to changes without notice.

Hand Knob

Rotate

7b

Pan/Tilt

NOTE: Do consult a qualifi ed and authorized service technician if you
encounter any technical diffi culties. We are not liable for any damage or
injuries arising from any improper installation or mishandling.

Step-7 —Adjustments:
7a. Projection distance (B) ­refer to Projector User Manual
and dependant on the required
diagonal size of image, adjust
the distance from the “face of
the whiteboard” to the “front of
the projector” (nearest part to
screen) by loosening the Hand
Knob and sliding the projector
mount along the wall arm.

7b. Pan / Tilt / Rotate Projector to
adjust the projection image onto
the screen.

Model: AV890-610

ABtUS SIGAPORE PTE LTD www.abtussingapore.com

ABtUS SINGAPORE PTE LTD www.abtussingapore.com

Revision 0

ABtUS SINGAPORE PTE LTD www.abtussingapore.com

User Operation Guide

PACKAGING CONTENT

Item-1
Wall Arm —1 set

Item - 2
Universal Mount
—1 set

Item - 3
Screw bag 1 —1 set

INSTALLATION

Step-1 — Mark the position on the wall for the Wall Plate as shown in Diagram 1.
Note: Mounting position will be

vary dependent on the Brand
and Model of Projector used.
Please refer to Projector User
Manual for installation details.

To find dimention A-1,
A-1 = (offset distance) - 6.15cm

To find dimention A, align Top
of image to the edge Screen or
refer to Projector User Manual
for details.

A

Lens

A-1

Offset distance

Item - 3
Screw bag 2 —1 set

Centre Line
of Wall Plate

CG of
Projector

Step-3 — Mount Wall Arm (Item 1
) onto wall by using the Lag Bolts
and Washers (in Item 4) provided.

Base
Spacer

INSTALLATION

Universal
Mount

Projector

Lag bolts and
Washers

Step-4 — Fix Universal Mount (Item 2
) with Base Spacer (“M” in Item 3) and
Screws (“A” -”I” in Item 3) onto Hitachi
projector.

Centre line of Image/
Projector Lens

Top of Image

Step-2 — Marks position of the Wall Plate mounting holes. Drill and insert Wall Anchors (in Item 4)
into concrete wall. Note: Do not use Wall Anchor for mounting on wooden wall.

markings

Hammer

Holes for
concealed cables

Gently

Push in

Step-5 — Lift and insert the assembled
projector (in Step-4) into the short
pipe adaptor of the Wall Arm. Insert
the Locking L-bracket (in Item 4) and
secure with M8 socket cap screw and
nut (in Item 4).

insert

insert

Locking
L-bracket

*Specifi cations are subject to changes without notice.